NF7-S Northbridge Fan

coastertux

Limp Gawd
Joined
Jan 20, 2004
Messages
311
I have a NF7-S v.2 and the Northbridge fan is very noisy for about 5 minutes (it sounds like it is chewing on something) and then quiets down. What should I do?
 
Replace it with a Vantec Iceberq cooler or something similar. The Zalman passive northbridge cooler is nice too. This is a known problem with the NF7-S, their northbridge fan is shit. Mine failed after 2 months of use.
 
Mine was so noisy i swapped it for the Yellow Zalman, now all is quiet, and cool too, unlike the southbridge, when i was using onboard sounds it was like 60 C !!!

Rob
 
Yeah, common problem. The NB fan dies easily, is pasted on poorly, and is a general hassle. I replaced mine immediately. Iceberq (NON PRO) all copper chipset fan or a Zalman passive heatsink are good replacements.

Whatever you replace it with, make sure it's a NB chipset fan/heatsink and not a VGA chipset fan. Iceberq looks EXACTLY like the Abit original, except it's copper-colored.
 
I bought an nf7-s 2.0 a few weeks ago, and had read all about the fan problem so I ordered the blue Zalman passive NB cooler and installed it on the mobo even before the mobo went into the case.

I can confirm the blue zalman works great.
 
I posted this reply to the same qestion in another thread:

"I would not recommend the Zalman, the mounting mechanism on their passive NB cooler is utter crap, the cheap pushpins and weak springs do not provide enough pressure to hold down the heatsink with enough force, infact my heatsink poped off after i've installed it, lucky for me my comp was off! Now Zalman does provide thermal epoxy but unless you're willing to use a permanent mounting method, I suggest you either look elsewhere for a better solution or improvise like I have (two screws and thumb nuts from a Zalman videocard heatpipe cooler). "

I have to clearify, I don't recommend the yellow zalman NB cooler as I have no experience with the blue zalman NB cooler and it's mounting system. Before I replaced the mounting system, my NB temps were reading around 100F on load at 400FSB and 1.6v. After I replaced the stock mounts, I never do 95F on load at the same FSB and voltage settings.
 
the nb1 worked great for me, I didn't notice any increase in fsb performance(since I just mess around and change so much in my system at once), but I can tell you the heatsink is relatively cool, I'm a bit worried it soaks up a lot of the heat off my neighboring slk947(u)+92 mm thermaltake fan, theres definately a big warm spot on either side of the heatsink.

<<< managed boot with 250 fsb, boot in windows at 240, but its only stable at 220-230, I suspect its my ch5 ram maxing out at 2.9 volts, could use voltage mod :)
 
Back
Top