NF7-S Disable RAID, Boot off one Serial ATA Drive?

BuGaLoU

[H]ard|Gawd
Joined
Apr 24, 2002
Messages
1,156
One of my hdds died in my raid 0 stripe and I wanted to just reinstall windows on the remaining working drive. I can't seem to disable the RAID bios though. There are no jumpers or no CMOS settings. Do you haveto use raid?
 
You'll need to delete the Raid 0 setup on the remaining drive. You should be able to do this by pressing a particular key or set of keys immediately after the initial post screen. You'll see a screen come up saying detecting raid drives or what not and it will tell you what to press to set up a RAID. You must go into this and delete the Raid 0 you had setup on the remaining drive in order for you to be able to use it again as a non RAID drive (when deleting the RAID, it might be necessary to tell it to rebuild the RAID 0 configuration before it will allow you to delete the RAID assuming that the original saved RAID configuration was corrupted or destroyed by the Hard disk crash). Otherwise, you'll have problems trying to detect it in Bios and trying to FDISK/Format it to install Windows. In fact from my personal experience, the hardware manufacture's SMART drive health montoring software will not be able to properly identify the drive if its setup in a RAID, at least for me, the programs kept giving a very odd Hexadecimal code for the drive instead of its actual model and what not. After I deleted the raid, things worked as they should again on those drives.
 
Back
Top