NF7-S and Raptor problems

TruthInRuin

Limp Gawd
Joined
Jan 14, 2004
Messages
286
This is really getting me mad :mad:

Well, I got a NF7-S and a raptor today, set it all up and it seems to be fine. Go to install windows and everything loads, get to the screen where it asks to either install windows or repair it. If i try either windows says it cant detect any hard drives. Yet when i get past the POST a quick screen shows it can see my hard drive. Im really confused, i made sure SATA was enabled, power is connected along with the SATA connector, the hard drive is even getting warm to the touch. I'm installing windows now an a 120 gig ATA drive.

Any help is appreciated, thanks
 
I have an NF7-S V2. It uses the very same Silicon Image Si3112r SATA controller, which requires drivers loaded from a floppy disk in order for Windows Setup to recognize your Raptor. You will need to use a floppy drive, and install drivers from the floppy disk. To do this, press F6 when instructed "Press F6 if you have a SCSI adapter" (or something similar). Then, when instructed during the copying of files, insert your SATA driver floppy into the floppy drive, then press the appropriate key to copy the SATA driver. Choose the one labeled "Silicon Image Si3112r Serial ATA RAID controller for Windows XP" if it gives you a choice between multiple SATA drivers.

After the files get copied and Windows is installed and configured, you may want to update the driver when you run Windows Update, as the driver version which came with your mobo is both old and not WHQL-certified - and the only WHQL-certified drivers for the Si3112r controller are available through Microsoft's Windows Update site.
 
I tryed that. when it asked me to insert the disk, i did and it said to press enter. once i pressed enter it just went back to the same screen asking me to put the disk in and press enter.
 
You may not have your floppy drive connected properly, or you may have the connector at the floppy drive end of the cable plugged in backwards. You see, floppy cables are all too easy to put in backwards, as far as floppy drives themselves are concerned. (One sure way to tell that is if the access light on the floppy drive stays lit all the time - in that case, then you've gotten the cable plugged into your floppy drive backwards.) Make sure that the red stripe is furthest away from the power connector or towards the right-hand-side of the drive (as viewed from the front faceplate of the drive).

Also, you might have either gotten a defective floppy driver disk, or a driver disk for the wrong motherboard.
 
Back
Top