Newly built computer, but the computer would not turn on.

EarthBrain

Limp Gawd
Joined
Sep 5, 2007
Messages
404
O.K. I just finished building the computer and was excited to turn it on for the first time.

Well, after pushing the power button, nothing would turn on.

My specs:

Intell Q6600 with Noctua NH-U9B fan/heatsink
DFI Lan Party Jr P45 MOBO
Antec 550 watts modular Power Supply
G.SKILL PI Black 4GB 240-Pin DDR2 SDRAM DDR2 800
Western Digital 640GBAAKS
300 gig WD Velociraptor
Visiontek 4850 graphic card
Antec Mini P180 case

Well, when I turn on the power supply, I can see some 2 tiny lights light up on the mother board. On the motherboard there is a small power button and reset button and even if I push on them, nothing would power up (not even the fans). Pushing the power button on the case would also not power anything up.

What did I do wrong? This is my first computer build.

The 12V power supply 8 pin is already plugged into the motherboard.

All the components/parts are brand new out of the box.
 
Did you connect the 4/8 pin power connector to the motherboard in addition to the larger one?
 
Plug in the 8pin power to the upper-left of the CPU socket?

I did that. Also, I see 2 tiny lights on the mother board so I am assuming that the motherboard is getting the power from the power supply.

This is so frustrating. I could not even get pass the 1st basic step.
 
Did you remember to use those standoff screws for the motherboard? If you didn't, then it can cause a short, and your computer won't boot up.
 
Is this power button power connector connected to the mobo?

Yes, the mini reset & power button is on the MOBO. You can see it on the picture below.

Sswitches.jpg
 
Try booting it with the bare essentials. Remove the Video card if you have onboard and no need for a hard drive either. PSU/RAM/CPU.
 
Dang, the cause is the power supply.

I just switch it with another power supply from my old Dell computer and the the computer start up and the fan of the power supply is spinning.

Now I have to drive to Fry's to get an exchange.
 
That's unfortunate, hopefully it didn't damage any of your other components.
 
Dang, the cause is the power supply.

I just switch it with another power supply from my old Dell computer and the the computer start up and the fan of the power supply is spinning.

Now I have to drive to Fry's to get an exchange.

At least you live near a Fry's and can do it. Are you merely going to exchange the 550W for another 550W? You might wanna build in some overheard room to grow with a slightly beefier PSU.
Glad you found the cause of the problem though
 
I've built a few PC's and typically the issues I have are with PSU's. Dunno what's up with that just bad luck or what but it's rather irritating and I feel your pain. As someone else said, at least you bought it at Fry's and there's one close by. Imagine if you had it shipped and had to send it back. That would drive me nuts.
 
Back
Top