New system keeps crashing on startup

endollan

n00b
Joined
Mar 2, 2004
Messages
11
Hi everyone,

I'm building a brand new system with the following specs.
gigabyte ds3 mobo
intel e6400
antec smartpower 2.0 500W PSU
2gb OCZ platium 6400 DDR2 ram
evga 7900 gt
antec lanboy case
asus silent square HSF
booting with an ata 200gb harddrive (will buy new sata in acouple of days)
No dvdrom install at the moment

When I went to power on the computer, it will turn on for like 2 second and then shut off, and then it keeps restarting and shutdown every 5 seconds, nothing comes up on the screen. Do you think I have a DOA mobo? Thanks for any help.
 
Thanks for the quick reply, I guess I'll go out and buy some crappy ram and change the vdimm to 2.0. It really sucks that I have to do this since I don't have any spare ddr2 rams.
 
your reset/power button could be stuck/shorted. this would account for the 5 second recycle(actually it would be 4 seconds). your 12v 4 pin/8 pins connector could be loose/disconnected.
 
I was thinking about getting the OCZ Gold DDR2-6400 for 199$ at ZZF, but then after hearing all the probs w/ it, w/ the DS-3, I decided to go w/ the GSKILL 2GB HZ DDR2-6400 seems to be OC memory from the masses over at Xtremesystems.org.

I should be able to start building things this upcoming week. WOOT
 
Yeah, from my research the Gskill HZ's and the Corsair XMS 6400's work with the DS-3's. I'm more familiar with the corsair brand so I decided to go with them.
 
Thanks for everyone's advice and reading from other sites. I went out a bought a cheapo ddr ram from staples and the system booted right now and I went into the bios and set the voltage to +.3. I have also upgraded the bios on my ds3 to (f4c)latest. Afterwards I installed the 2GB of OCZ platinum and it booted fine. I was able to OC my e6400 to 3.2gh and runs stable with memtest86 and prime.

I can't seem to ever run dual prime. I can open one but then the other would app would crash. I read the instruction to start the next app with an (-a1) extention. I did and it still won't work. Oh well, the system is running at 32C on idle and 44 on load with 2 seperate apps. Not sure if the temp will go higher since I didn't stress it with both cores for a lenght of time.
 
Back
Top