New system doesn't boot

TomH

n00b
Joined
May 22, 2007
Messages
5
I just received new parts and installed them, but I only get black screen. All fan's and hd starts, but no picture. All cables are plugged correctly, cmos cleared, started without dvd- and harddrive, but no. Does DFI have some issues with PQI memory or is it power supply? Any suggestions?

DFI Infinity P965S
C2D E6420 + Scythe Infinity
2x PQI 1gb DDR2-800
Leadtek 8800GTS 320mb
Antec P150 + NeoHE 430W
 
Reseat the CPU. Try with a single stick of RAM. Is everything installed in the case, or sitting on your desk? If all in case, make sure there aren't any shorts. That PSU is iffy to me.
 
Ok, I took mb off the case to the desk. I reinstalled cpu and tried with only one memory stick, but no. This time mb makes a single high pitch noise. Manual said, that it might be memory problem. Maybe tomorrow I can test with another memory stick.
 
Did you try all slots? I havent read up much on the DFI board, but I'd assume it could post with that PQI ram, even though its rated for 2.0v. Hm... is DFI street still around? lol.
 
It has 4-pin connector. I plugged it to mb's 8-pin +12V power connector, like manual says.
 
I went to local computer shop and we tested all the parts (power supply, memory, cpu, graphic card and mb). Problem was the motherboard, which didn't work with different memory, power supply or graphic card. It just beeped and booted itself in loop. All my other parts worked perfecly in different mb.
 
Back
Top