• Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
    Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.

New mcp355/ddc3.2 ?

B

basserdan

n00b
Joined
Jul 9, 2006
Messages
37
I received an mcp355 today along with EK DDC v2. I was about to swap the tops when I noticed one of screws on the pump has a stripped head, (the phillips groove). Has anybody had this experience? The screws seem kind of cheezy and soft. As well, it seems the last few turns when tightening are kind of hard. It could have been done in assembly but...
If this is a common occurance, I'll just keep the pump. If not, I almost have to assume that someone else has messed with it. Man I hate waiting for something only to have to wait twice as long all over again!
 
I just bought the same setup MCP355 and EK DDC V2 and had not problem with removing the original scres that came with the pump.

Also the replacement screws that came with the Top went on smoothly on to the pump.
 
You must log in or register to reply here.
Back
Top