new computer, cant get 260 card to work.

solesk

n00b
Joined
Nov 23, 2008
Messages
6
Ok, i just built a new system. yes, my first build, but it seems to have gone fairly well. except for a few problems.

  • i have tried 3 different bfg nvidia 260 cards, and none would do anything. no led, no moving fan, doesn't even get warm. and most importantly, no picture, ever, not even during boot.
  • because of that, i have an old bfg nvidia 7900 card in, but it runs hot. 80°C idle, and can get as high as 110° gaming.
  • the case fans do not come on by themselves. but if i give them a quick flick, they'll run forever.

at the bottom is a list of the hardware i bought. but first, what i've tried.
  • old video card works fine, aside from overheating.
  • tried uninstalling drivers first. but bfg tech says this shouldnt matter. i should at least see the bios screen.
  • vista 64 loads fine. no problems at all.
  • i had some early problems with ram, but setting the right timing fixed all that. they pass mem test fine.
  • i've tried both speedfan and hwmonitor to see if my 12v rails from the psu are putting out the correct volts. both give odd numbers like idling at 0.7v and maxing at 4.5v while gaming.
  • because of that i bought a volt reader. (the 7900 requires only one 6 pin cable for power as apposed to the 2 for the 260). the volt reader read a consistant 12.26v on one of the 6 pins and 12.34v on the other. they fluxuate very little on boot, idle, or heavy gaming (heavy gaming being cod4 at full settings. i dont have crysis).
  • i have tried both ports on the back of the 260 cards, with multiple cables, neither does anything.
  • i tried the included adapter power cable. and no combination of the 3 power cables produced any result.

i thought maybe i had narrowed the problem down to my psu, but the volt reader seems to say it's working fine. it sounds like hwmonitor just isnt reading right. which is probably true, since i'm not sure i could boot off 0.7v. can the two cables being off by 0.1v be causing the problem?

it would seem very unlikely that i've gotten 3 bad cards, 1 from newegg and 2 from bb. one had even been resealed by bfg as certified retested, if that means anything. but i have read several stories online, including this forum, where people have gone though 3 or 4 260's before getting a working one. however 3 dead cards does not explain the 7900 overheating or the fans not comming on by themselves.

the first card, when starting up the system for the first time, showed the bios screen for the first 2 boots, and then never again. the other 2 card never showed anything. and the 7900 card uses the same slot, although it's only pci-e, not x16.

as near as i can tell from reading all the manufacturer's websites, everything is compatable.

you guys have any suggestions of more stuff i can try? i have a 4th 260 card, this time evga, arriving tomorrow. if it doesnt work i'll try to put it into a friends system. although that will be hard. i think i only know 1 with a pci-e2 slot.

i'm out of ideas, i've tried everything anyone has thrown at me, and all i've been able to do is rule out what it's not. i need help.

my hardware:
Case - Antec P182
Motherboard - GIGABYTE GA-EP45-UD3R
Processor - Intel Core 2 Quad Q9550 Yorkfield 2.83GHz
PSU - ZALMAN ZM750-HP 750W
Video Card - BFG Tech BFGEGTX260896OC2E GeForce GTX 260
Ram x2 - OCZ Reaper HPC 4GB (2 x 2GB) 240-Pin DDR2 SDRAM DDR2 1066
Hard Drive x2 - Western Digital Caviar SE16 WD6400AAKS 640GB 7200 RPM
Cooler - Tuniq Tower 120

new card on order:
EVGA 896-P3-1260-AR GeForce GTX 260

i'm hoping a non oc'd card might make a difference. but i dont see how.
 
If I read correctly, your new computer boots and runs fine with all the hardware, as long as the older 7900 video card is in place????

That is you can play games and scoot the internet, etc.

But when you put in the 260, nada.

I'm stumped, but before you cook a 4th card, get or borrow a different power supply, that seems to me to be the only problem; given that the less demanding GPU allows the computer to work.

I'd get a Corsair 750 or even 620W

A new GPU isn't the problem. It would be nearly impossible for three GPUs from the same company go bad. The board seems to be OK, and if all else works in consert when the 7900 is placed.............its the PSU.
 
I'm with magoo here, there are some weird issues with PSU's not working with a certain model of board/card.
 
read guys

"i tried the included adapter power cable. and no combination of the 3 power cables produced any result."
 
yes. the computer works fine, great even, with the 7900 card. aside from the card overheating. i can surf the web, play games, download torrents ect. i've played wow, cod4, fallout 3, and c&c red alert 3 all fine.

and yes, both cables are listed as pci-e cables from the power supply. one is modular, one is from the original set. i tried the adapter to fit 2 of the old 4 prong plugs also. nada.

i'm not an expert on using the multireader though. i can read volts, but i dont know how to read amps. so maybe the plugs arent putting out enough combined amps for the 260 card? i mean the mb takes a 12 prong cable and 2 4 prong cables. maybe it's not outputting the proper amps and the vid card cant fire up? i'm just guessing.

but regardless it sounds like i need to try another psu and see what happens.

am i really running the risk of frying the video card though? or is it just not booting up? should i not try the new card until i get another psu to try it with?
 
There are a lot of deals going on this week for high quality PSU's in the hot deals forum. Buy one of them and see if that's your problem. It's not the video card. But definitely make sure you've got everything plugged in that's suppose to be on the card and everywhere else.
 
try the card in the slot WITHOUT any power connectors. it should BEEP like crazy. if thats the case, theyre at least doing something. if they dont, id say its mobo related.
 
I'd guess that you burned sonething up on the mb that the 7900 card can somewhat overcome but the 260's cannot. Start testing the 260's on another mb. You need to verify that they work. Verifying that the 260 actually works (provided the mb did not burn it up) I'd toss the mb and get a new one.
 
totally sounds like a power supply problem. Unless you haven't connected the proper power cables to the 260..
 
the case fans do not come on by themselves. but if i give them a quick flick, they'll run forever

This is very suspicious to me. The fans should not be having any trouble starting up by themselves.

I call shenanigans on the PSU.
 
well i think i found the problem with the fans. i didnt think to look before. but it seems on their lowest setting they have trouble coming on. maybe it's an auto setting. i don't know. but if i turn them up a little. they come on just fine. so i think i'm good there. turning them up also keeps my old video card down around 80c. although i think it's still not right because it idles high, setting the fans higher definitely helps.

in any event. i have a new mb and power supply on order. i think i'll try the mb first.
 
well i think i found the problem with the fans. i didnt think to look before. but it seems on their lowest setting they have trouble coming on. maybe it's an auto setting. i don't know. but if i turn them up a little. they come on just fine. so i think i'm good there. turning them up also keeps my old video card down around 80c. although i think it's still not right because it idles high, setting the fans higher definitely helps.

in any event. i have a new mb and power supply on order. i think i'll try the mb first.


try the power supply first! if its the psu it could damage the new mobo, possibly. thats just what I would do.
 
You may have a BIOS setting wrong somewhere as well that is preventing the video cards from working correctly???? It's a stretch, but look through the BIOS settings and see what may have been incorrectly adjusted.

I still think your PSU is FUBAR'd.

Happy Thanksgiving.:D
 
with the way the case fans are reacting, i'm callin out that zalman psu, or a mystery short somewhere.

tried everything out of the case on a static free surface?
 
yeah i vote psu as well. I have an antec case and never take the stock fans off of the low setting and they have no trouble, not even the 140mm.
 
If you do a search for your power supply you will find 3-4 threads from users with the exact same one who have pretty much the exact same problem. Those Zalman PSU's are trash.
 
Shitty or defective power supply is my guess. The GPU's you have gone through probably werent dead either...just not getting enough power to get going. Dont ever, EVER skimp out on the powersupply. If anything, that should be the highest quality component in your case.
 
Try updating your bios.

edit: saw this on the gigabyte website,
Download from ... F6 2008/06/19 Fix VGA compatibility issues
 
well the new card arrived. my curiosity overtook me and i tried it in my cpu. got nothing. but i did take it to my friend's to try in his computer afterwards, and it works fine. so i'm down to pretty much my mb or psu. i ordered a new psu and mb that arrive tuesday. i'm thinking of just swapping them both out and calling it a day. i ordered an asus board this time (so that the vid card would sit lower and not interfere with the hd mounting) and a corsair psu.

i didnt mean to skimp on the zalman power supply. i was just looking for something modular and it looked like a good deal.

cross your fingers for me. and thanks for the help so far guys.
 
well the new card arrived. my curiosity overtook me and i tried it in my cpu. got nothing. but i did take it to my friend's to try in his computer afterwards, and it works fine. so i'm down to pretty much my mb or psu. i ordered a new psu and mb that arrive tuesday. i'm thinking of just swapping them both out and calling it a day. i ordered an asus board this time (so that the vid card would sit lower and not interfere with the hd mounting) and a corsair psu.

i didnt mean to skimp on the zalman power supply. i was just looking for something modular and it looked like a good deal.

cross your fingers for me. and thanks for the help so far guys.

Aren't you going to try to flash the bios? It says right on the Gigabyte website that one of the newer bios for this board fixes vga compatiblity issues. Why not try it. What do you have to lose? Good Luck;)
 
unless their website is wrong, the newest bios for my board is f4, the f5 and f6 are for other boards. and i'm already using f4.
 
wohoo! system is working!

new motherboard and psu arrived today. i decided to scrap both my old ones to be on the safe side. took a couple hours to make sure everything was exactly right.

booted up on the first try with no problems. just alot of new drivers to install. and everything installed without a hitch.

cpu is operating at ~50°
gpu is idling at less than 50° and under load less than 70°
and all my fans work on the lowest setting, which they did not before.

i'm getting 40fps in wow at full settings in northrend. 8x multi sampling.
and 91fps in cod4 at full settings.

so thanks to all you guys for your help! now i need some food.
 
Back
Top