New comp, help plz [H] gods!!

BobV111

n00b
Joined
Aug 9, 2006
Messages
6
Just got my new comp, but am having a prob. To start here are the specs;

VGA PNY GF7600GT 256M VCG7600GXPB R
MB ABIT KN8 SLI NF4SLI 939
CPU AMD|A64 3800+ 2.4G 939 512K R
CORSAIR XMS 512MB 184-Pin DDR SDRAM DDR 400 (PC 3200)

The problem is when I boot from the windows XP Pro CD to install it, it goes to that first black "checking your system configuration" screen for about 3 seconds than just goes black, and the cd drive stops instead of going right to the blue screen and loading all that windows crap. I tested the cd & cd drive and both work. Any ideas on why it might be halting?

Any help or input at all is greatly appreciated!!!
 
Have you disabled all peripherals in your BIOS (including USB)? You can re-enable them later after windows has installed. Try to use a PS2 keyboard/mouse during setup.

Also try a second windows disk if you can.... Mine appeared fine when I experienced problems - replacing the disk helped me find the next problem in the chain.

next, you could test your RAM settings by using memtest86

You might also need to select the correct HAL when starting windows setup. When the first screen pops up asking for RAID/SCSI drivers (F6 key), press the F5 key instead. Arrow up to the option ACPI Single Processor. If this doesn't work you can try other HALs to see if you make more progress.



There are several other things to try as well... I had to fight with my PC for 2 days to get windows installed, I hope you have better luck!
 
BobV111 said:
Just got my new comp, but am having a prob. To start here are the specs;

VGA PNY GF7600GT 256M VCG7600GXPB R
MB ABIT KN8 SLI NF4SLI 939
CPU AMD|A64 3800+ 2.4G 939 512K R
CORSAIR XMS 512MB 184-Pin DDR SDRAM DDR 400 (PC 3200)

The problem is when I boot from the windows XP Pro CD to install it, it goes to that first black "checking your system configuration" screen for about 3 seconds than just goes black, and the cd drive stops instead of going right to the blue screen and loading all that windows crap. I tested the cd & cd drive and both work. Any ideas on why it might be halting?

Any help or input at all is greatly appreciated!!!

Did you build this system yourself? If so, check to make sure every thing is connected tightly, make sure you have a power supply that puts out enough power, and make sure the heatsink/fan is installed properly on the CPU..

In the detection process, does your computer turn off, or lock up? Usually when I had something like that happen on a install, the install would start up again at the point where it locked up and continue fine.. unless your talking about the inital loading of the drivers (the first blue screen, before you even partition your drives)

edit: looked up that MB real quick.. you never mentioned if you have your HDD's in RAID or not.. if not, go into your bios and disable the RAID.. It might be called something like RAID Boot ROM..

edit 2: If you built it yourself, and feel comfortable re-doing the bios settings, I recommend you clear it.. I've had a couple systems that acted.. weird (out of the box), until I cleared the bios.
 
AHA!!!! After tinkering with BIOS and a bunch of other stuff, I finally threw in my HDD floppy and did a low level format and that took care of it. Thank you all very much for your replies!!! :D :D
 
Back
Top