New build o/cing input needed

[nbovk951]

My new system
coolermaster centurion 590
e6750 w/arctic cooling freezer 7 pro
DFI Lanparty p35 t2rs
2x2gb corsair xms2 ddr2-800
8800gt

with my mobo in my sig, I couldnt o/c anything past 3.0ghz. Im at 3.2ghz right now running just fine. I tried going up to 3.4 but I think I need a little voltage adjustment. But i dont know exactly where to start.
any ideas?

 

[nbovk951]

well i guess i figured it out on my own. It was all in the voltage.
what should I be running for V at 3.6. Im right at 1.5 right now. But I could most likely go down. Help bring temps down a little to
Im at 20-23idle and 45-50 at 10 minutes 100% cpu. Thats with all my cooling at less than 50% because im trying to get a good overclock without my setup sounding like a jet. But even at high speeds. These 7 120mm fans are pretty quiet still.

 

[UtopiA]

1.5v in your bios?!
I wouldn't go any higher.

23 idle at 1.5v just isn't possible unless you're on water.
I guess the E6750's really do have temp reading problems, huh?

 

[nbovk951]

it was showing that voltage in cpu-z. Core temp was reading about 34* when the dfi software was showing 27*. Who do I believe.

anyways I just ran 3dmark06 stock and then with overclock from 2.66 to 3.6ghz
and the 8800gt from 600/900 to 700/1000 gained 2887 points. Not to shabby eh?
stock

overclock