New AMD build

Injen

Weaksauce
Joined
Dec 20, 2012
Messages
80
Hello guys.
A few years ago, I planned to build a new computer. But life got in the way, so I put it off. Even if the prices are completely upside down. Even though prices are completely upside down, I have to buy a new computer.

CPU: 9850X3D
Motherboard: ASRock X870E TAICHI OCF
Memory: Usually, I buy memory from G-Skill, like Trident Z5. But i just noticed that Patriot Viper Venom DDR5-6000 is almost 50% of the price for a equivalent memory from G-Skill. Sure, I wont have that fanzy RGB. I have never tried Patriot memory though and i don't know how good they are. Both have AMD EXPO.
GPU: I gonna go for team red this time. 9070XT. Since I run custom watercooling, I don't care about the appearance. PowerColor Hellhound or Red Devil? Hellhound are almost 300$ cheaper, but at the same time I've seen people complainig about coil-whine with the Hellhound. Any other ideas of brand and model?
Storage: Again i have no clue what to buy. Crucial T710 2TB M.2 seems to be pretty good, but there is much cheaper and slower options.

Any advice would be appreciated.
 
1795118458704.png

patriot ram has been fine for me, no rgb was a bonus.
get whatever 9070xt costs the least and undervolt/oc it. my reaper 9070 does 9070xt speeds...
they all have coil whine when pushed to the max, limit fps to your refresh rate will cut out most of it or live with it.
crucial is good, just dont buy the cheapest nvme you can find.
 
Are you going to be doing content rendering or creation? That's a lot of CPU you got there.
 
I can chime in on Patriot Viper RAM. I've got a 64GB 6000C28 EXPO kit in my backup rig (X670E Steel Legend, 9800X3D). It's not stable at C28, but works fine at C30 (and tighter sub-timings).

For the GPU, I'd buy from a place with a good return policy in case you aren't satisfied (coil while, etc.).

For the SSD, I'd lean towards getting a TLC drive over a QLC drive. Especially if you are just using a single drive. TLC can handle a lot more writes to it over time than QLC, which matters if you plan on keeping it for years and use it as your boot drive.

Edit: Don't skimp on the power supply. It can last through many upgrade cycles, and is the most important component (because a poorly made one can kill the rest of the PC).
 
patriot ram has been fine for me, no rgb was a bonus.
get whatever 9070xt costs the least and undervolt/oc it. my reaper 9070 does 9070xt speeds...
they all have coil whine when pushed to the max, limit fps to your refresh rate will cut out most of it or live with it.
crucial is good, just dont buy the cheapest nvme you can find.
Thanks. When you say all, do you mean all 9070XT or all 9070XT coming from PowerColor? I have not tried AMD since way back when i had two 7970 running in CF. It will be fun to try them out again.

Are you going to be doing content rendering or creation? That's a lot of CPU you got there.
BlueStacks, Bluebeam, Photoshop, Video editing and gaming ofc. When i buy new parts i always go top tier just to future proof.

I can chime in on Patriot Viper RAM. I've got a 64GB 6000C28 EXPO kit in my backup rig (X670E Steel Legend, 9800X3D). It's not stable at C28, but works fine at C30 (and tighter sub-timings).

For the GPU, I'd buy from a place with a good return policy in case you aren't satisfied (coil while, etc.).

For the SSD, I'd lean towards getting a TLC drive over a QLC drive. Especially if you are just using a single drive. TLC can handle a lot more writes to it over time than QLC, which matters if you plan on keeping it for years and use it as your boot drive.

Edit: Don't skimp on the power supply. It can last through many upgrade cycles, and is the most important component (because a poorly made one can kill the rest of the PC).
Not sure if we have any store with that kind of return policy, but i'll have a look at it. Thanks :)
I have not decided yet if i should go with 1TB NVMe and a 2.5" Sata SSD for extra storage "I got a bunch of they unused" or just a 2TB NVMe. The Samsung 9100 PRO 1TB looks great but the price is insane.
I already have all the other parts except for new waterblocks. Think it gonna be XSPC RayStorm for the CPU since i've had really good temps with them and Alphacool Core for the GPU since that's all i can buy online.
 
Thanks. When you say all, do you mean all 9070XT or all 9070XT coming from PowerColor? I have not tried AMD since way back when i had two 7970 running in CF. It will be fun to try them out again.
all brands, basically all gpus these days have coil whine when pushed to the absolute max
 
  • Like
Reactions: Injen
like this
CPU: 9850X3D
You'll want a good cooler for it, something like a 360mm AIO, especially if you want PBO+200 and CO-30, which it'll easily handle.

Motherboard: ASRock X870E TAICHI OCF
Good motherboard, I have a Z890 Taichi OFC, and it's a solid board.

Memory: Usually, I buy memory from G-Skill, like Trident Z5. But i just noticed that Patriot Viper Venom DDR5-6000 is almost 50% of the price for a equivalent memory from G-Skill. Sure, I wont have that fanzy RGB. I have never tried Patriot memory though and i don't know how good they are. Both have AMD EXPO.
Manufacturer is a personal choice, most likely based on warranties. What really matters is what's underneath, the speeds, and then timings. You don't need anything over 6000MHz, so choose the tighter timings if there's a difference.

GPU: I gonna go for team red this time. 9070XT. Since I run custom watercooling, I don't care about the appearance. PowerColor Hellhound or Red Devil? Hellhound are almost 300$ cheaper, but at the same time I've seen people complainig about coil-whine with the Hellhound. Any other ideas of brand and model?
Best price per performance is a RX 9070 16GB, but if you find a good deal on a RX 9070XT 16GB, go for it. Hellhound is a solid card, and Red Devil's are more enthusiast. I've had no issues with coil-whine on RX 9070 16GB Hellhounds I've used, but then, I'm getting old and maybe my hearing isn't the best, anymore. If you know how to undervolt (which also overclocks), the Hellhound won't disappoint compared to the Red Devil in regards to performance.

If you want to switch to AV1 video editing to save space and have better quality, I recommend a used RTX 5070 12GB. Some overclock really well, and it performs better than a RX 9070 16GB, but worst than the RX 9070 XT.

Storage: Again i have no clue what to buy. Crucial T710 2TB M.2 seems to be pretty good, but there is much cheaper and slower options.
I personally choose multiple SSD's for my setups. Since you do a lot of video and photo editing, as well as gaming, I recommend you to do the same. TLC vs QLC, most would choose TLC, but if you're not doing a lot of writes, QLC is fine. I typically use a 512GB NVMe SSD for my OS and apps. Another 512GB or 1TB SATA SSD for my photo editing and video editing (I also allocate space on my RAM as a RAMDisk, and that's my temp cache and work area for smaller projects). Hard drives for storage. Then a 1TB or 2TB NVMe or SATA SSD for games.
 
You'll want a good cooler for it, something like a 360mm AIO, especially if you want PBO+200 and CO-30, which it'll easily handle.
No worries. I have two Alphacool NexXxoS UT60 Full Copper 420mm Radiator. One for the GPU and the other for the CPU and both with a separate pump/res system

Good motherboard, I have a Z890 Taichi OFC, and it's a solid board.
Thanks. I like the look of their boards. How is the software?

Best price per performance is a RX 9070 16GB, but if you find a good deal on a RX 9070XT 16GB, go for it. Hellhound is a solid card, and Red Devil's are more enthusiast. I've had no issues with coil-whine on RX 9070 16GB Hellhounds I've used, but then, I'm getting old and maybe my hearing isn't the best, anymore. If you know how to undervolt (which also overclocks), the Hellhound won't disappoint compared to the Red Devil in regards to performance.
There's only a 200$ different between the non XT and XT versions so i think i gonna go with the XT
 
No worries. I have two Alphacool NexXxoS UT60 Full Copper 420mm Radiator. One for the GPU and the other for the CPU and both with a separate pump/res system
Lol, now that's overkill.

Thanks. I like the look of their boards. How is the software?
I don't really use any motherboard software. I tried using software once (I think it was ASUS), and it caused issues.

There's only a 200$ different between the non XT and XT versions so i think i gonna go with the XT
When the difference was $20, it was better to get the XT version, but $200, I don't think it's worth it. But, it's your build, and the XT version doesn't disappoint.
 
  • Like
Reactions: Injen
like this
Lol, now that's overkill.
It depends on how you look at it. Those bastards has been with me for 10+ years now and they took my 8700K to 5.4GHz at 46c under load and my two overclocked 1080TI while SLI still was a thing. Damn i miss that time
When the difference was $20, it was better to get the XT version, but $200, I don't think it's worth it. But, it's your build, and the XT version doesn't disappoint.
It's either a XT or a 5080 and since i want to go team red it will be XT. Thanks for the advice though.
 
Back
Top