Need help with new mobo

TTS

n00b
Joined
Nov 21, 2004
Messages
24
Well, I got the final part for the fist comp I am building for Christmas, now just putting it together. But, I got a problem. I plugged in all the cables and pushed the power button. Nothing whatsoever (fans don't spin, hard drive does't do anything, etc.) So, I tried moving the Pwr Sw cable a few times on the mobo, in case I forgot something, but I still can't seem to get anything. Any suggestions? This is my setup:

ASPIRE Dreamer II
ASUS K8N-E Deluxe
AMD Athlon 64 3400+ (Socket 754)
512 MB Crucial PC-2700 333 MHz
WD Caviar 160 GB 7200 RPM
TurboLink 350W Power Supply (came with the case)
 
The situation for nothing happen after a power start button pushed.....


1) Memory stick conflicts, and you might have to change another new one, so as to know if you are facing this embarrassment

2) PSU is not so generic....change another new and famous name PSU....

3) Caution again to all the cables you connect.....
 
Same thing happen to me... I just forgot to flip the switch on the back of the PSU
:confused:
 
Stanley Ding said:
The situation for nothing happen after a power start button pushed.....


1) Memory stick conflicts, and you might have to change another new one, so as to know if you are facing this embarrassment

2) PSU is not so generic....change another new and famous name PSU....

3) Caution again to all the cables you connect.....
1. The RAM is fine, I had it in another box before using it here, so it's not bad.

2. Thanks, I'm looking into getting an Antec TRUEPOWER 550, figure I won't have to upgrade til 2015 :p

3. Could other cables (reset sw, hdd indicator, etc.) be a problem? I didn't have them plugged in.




And Ender...... I'm a n00b, but not that much of one ;)
 
I fogot to connect the square 4-pin connector on my new motherboard. As soon as I figured that out, it worked like a champ. Before that, the power switch would turn it on, but it would just sit there.
 
No, both the 20-pin and 4-pin power units are connected, that was the first thing I checked.
 
...saw your post because I'm looking forward to assembling an A64 rig later this week :D

I've had this happen where I simply had a floppy cable reversed (cpu fan would turn about 10 degrees and then stop - had to pull the cord to reset something in the power supply), but there are so many possibilities. Best to check the most obvious first (which it sounds like you did) and then work back. Reset switch and hdd indicators shouldn't matter.

Since you have no power, it might be best to consider whether the MB standoffs are properly installed (I fried an ABIT MB with this one once) with no extras "holding it up" (all are matched to holes and scewed in). If you are 100% sure on that you might skip pulling the board back out. At least make sure there are no extraneous metal parts touching the MB anywhere (or a power cable - those three pin fan power connectors are good for this - shorting on some odd metal part of the case). If everything checks out, then start by disconnecting things and seeing if you can post up. Start with the floppy and hard drive, put in a low power older video card. If still no joy, try another stick of RAM. If it fires up then I'd put in a rush order on that power supply :p

Check this post too: http://www.hardforum.com/showthread.php?t=846847

Good luck :cool:
 
Thanks for the help. And, I might have figured out the problem....

When I plug in the power cable, the fans don't spin. At all. So..... I think I might have a bad power supply.... and Newegg is calling :)
 
Back
Top