The Chosen One
[H]ard|Gawd
- Joined
- Feb 4, 2001
- Messages
- 1,290
Hi guys, ive got a Leadtek 8600GT that im trying to volt-mod, but unfortunately (as this is my first attempt at such a mod) im not sure what to do as i can find no guides specific to this card's PCB.
I have seen the VRzone review of the Inno3D and the Palit, and i believe the eVGA and the Asus PCB resemble the Inno3D's layout...but unfortunately neither matches my Leadtek.
As a result im not sure where to read the GPU or memory voltage, and not sure which resistor to pencil to raise voltage on each.
I have managed to locate a picture of the back of an already hard-modded Leadtek 8600GT...but being new at this, i need furhter instructions.
Can anyone shed some light on this for me? If you need me to take a better closeup of my card, let me know and ill get one.
Thanks in advance.

I have seen the VRzone review of the Inno3D and the Palit, and i believe the eVGA and the Asus PCB resemble the Inno3D's layout...but unfortunately neither matches my Leadtek.
As a result im not sure where to read the GPU or memory voltage, and not sure which resistor to pencil to raise voltage on each.
I have managed to locate a picture of the back of an already hard-modded Leadtek 8600GT...but being new at this, i need furhter instructions.
Can anyone shed some light on this for me? If you need me to take a better closeup of my card, let me know and ill get one.
Thanks in advance.
