Need help troubleshooting new build: No video.

I3eyond

Gawd
Joined
Jan 14, 2006
Messages
937
Setup:

EVGA 680i
E6600
EVGA 8800GTX
Corsair Dominator 2GB 4-4-4-12
Antec Truepower 2.0

Problem:

Computer boots with a single beep, then hangs on 75, which is "Detect IDE; Detect IDE Device"

I'm running 2 SATA hds; only IDE present is with the cd-rom. After pulling the IDE cable, it still hangs on the same code.

I'm not getting any video; monitor light stays on standby.

Not a problem with my 8800GTX because I've been using it in my last build. (or my monitor)

24-pin power connector connected. I don't have an 8-pin supplementary, so, as the manual says, I have the 4-pin connectd to the 8-pin.

I also have a molex connected to the auxilary power for graphics.

Both 6-pin PCI-E cables are connected to 8800GTX.

Help!
 
I also have a molex connected to the auxilary power for graphics.

I was under the impression that you only hooked that up if you were running SLI, Idk about the newer 8 series cards though.
 
Did you try to reset the CMOS?

Sounds like a possible mobo issue, though Im really not sure what the problem would be.

Does the mobo have onboard graphics? Maybe try that, and also try to boot w/ no hard drives plugged in?
 
Yes, I reset the CMOS.

No onboard graphics.

I'll try the hard drive strategy in a few.
 
Are the only two symptoms of no video on boot either a faulty graphics card or a faulty motherboard? Or could it be in some way my error?
 
Back
Top