Need Help - Toasted pin on a 9800 Pro

bluey424

Limp Gawd
Joined
Mar 4, 2004
Messages
315
Well, I got to Quakecon 2 weeks ago, fired up my comp, and told the people around me that my system was acting weird (instability in a system that was generally rock-solid, just all around not of the norm). Instead of doing what I should of done, opening up the system and checking it out, I kept playing for the rest of the day.

Day 2

I come down and my computer is shut off. I figure someones just being a jackass, and I fire it up. It boots up and says that my ATI drivers aren't corrrectly installed. I reinstall them and it asks me to reboot. It comes back up and says that my power plug on my 9800 pro isn't plugged in. I *sigh*, pop the top and get a whiff of smoke. Apparently in the couple hour drive to Quakecon, my external power came a bit loose on my card and over the course of a day, cooked a pin on it.

pinshotsmall.jpg


It still boots up to that same error message now. I believe it's getting that error because it's not making good contact due to the scoring on the pin. Has anyone had a similar issue? Is there any way to salvage the card?

Here's some more pics:

Card Top
Pin Shot 1
Pin Shot 2

Thanks
 
well, are you sure it's just the pin that is damaged? i mean couldn't the heat have affected the circuitry around it?

just something to think about..
 
Hmmm... If you're willin to trust another Ag, I'd suggest taking a pencil eraser and seeing if you can clean the scorched crap off of the pin in the molex. It might help you get good contact again and it certainly isn't going to hurt at this point. If the eraser doesn't work, you can carefully scrape the scorched area with a jewelers file to get clean metal again. If it's just a matter of a bad connection through all that oxidized metal, that should do the trick.

G/L
 
Morazl said:
well, are you sure it's just the pin that is damaged? i mean couldn't the heat have affected the circuitry around it?

just something to think about..

Of course there's no way for me to know 100%, but I suspect it's just the pin because I don't see any visible damage besides the pin, even in that pins connection point to the circuit board, and the error.

Rori said:
Hmmm... If you're willin to trust another Ag, I'd suggest taking a pencil eraser and seeing if you can clean the scorched crap off of the pin in the molex. It might help you get good contact again and it certainly isn't going to hurt at this point. If the eraser doesn't work, you can carefully scrape the scorched area with a jewelers file to get clean metal again. If it's just a matter of a bad connection through all that oxidized metal, that should do the trick.

Yeah that's pretty much what I was thinking too. Must be that Ag-engineering. Maybe I can sell it or trade it on the FS/FT forums to someone else who want's to give it a shot if I don't get lucky with it.
 
Back
Top