Need help setting up WC gear

[aggpirate]

WelL I have all my WC gear and all. I just need to know how to set it up. I can set it up outside the case and have, so thats not my problem. Were should i put the 3x120mm rad. I also have a enhiem 1250 pump. If it matters I have a li lian v1000b
Thanks!

 

[aggpirate]

No one?

 

[Erasmus354]

3x120 will have to be externally mounted in that case most likely.

 

[aggpirate]

So Should i just put the wc gear in an old case?

 

[Top Nurse]

Do you have a 360 rad or three separate 120's?

 

[el rolio]

why dont you put it on top like so many do or will it run longer than the length of the case? like externally, on top. like koolance does in their modded case.

 

[aggpirate]

I can put it on top.Should i drill holes so the tube can go throgh?

 

[n64man120]

Yea, you could just mount it and drill 2 holes for the tubes and put some C-strip or something around them to make sure it doesnt cut the tubing.

 

[Top Nurse]

Push-fit bulkhead connectors work much better.

 

[aggpirate]

Just went and got the drill bit and i noticed that i got the wrong fucking block so i need a new one. 8 ( well my new vide card is not here so i can wait.\

Should i go
Res----> Pump-------> Rad---------> Waterblock---------> Res?

 

[Erasmus354]

Just went and got the drill bit and i noticed that i got the wrong fucking block so i need a new one. 8 ( well my new vide card is not here so i can wait.\

Should i go
Res----> Pump-------> Rad---------> Waterblock---------> Res?

Go like this : Res ---> Pump ---> Whichever order makes the smallest length of tubing

The only thing you need to consider is putting the pump after the res.