Need help, Epox nforce 2 board

Jared701

[H]ard|Gawd
Joined
May 9, 2002
Messages
1,587
cant find the model number from this book. my friend told me that he either shut down the computer then it wouldnt boot, or left for the night with it running and when he came back it wouldnt boot. the fans turn on but no beeps or anything... tried clearing the cmos, didnt help. the led shows c3 which i cant find in the back, but c3h shows expand compressed bios code to dram. is his motherboard shot or cpu? i have no idea what to tell him... please help
 
Being the friend talked about....I don't remember the number specifically, but it is the epox nforce2 board with the onboard 64mb graphics card. I camed home at 3am and when I went to check email, nothing happened. I tried restarting several times, but it doesn't even makes the beeps when it restarts like it's posting or anything. And the monitor stays in sleep mode and says no video signal is being sent. I have a separate gfx card that I use, so I moved off it and tried the onboard, but no luck there either. Perhaps the ram has died? It was Geil 256DDRx2 running eff. at 400mhz. Never had issues with it before. Any help is appreciated.
 
IIRC, I had the same problem with my new board and a bad stick of RAM.
Try pulling the RAM and reinserting one stick at a time to see if one is bad.
 
Mine didn't make any noises at all. Yours may be different though.
Can't hurt to try it. Takes less time to test it than it does to get a reply here.
 
Hmm, tried the ram suggestion, well, at least in the two dimms I can reach without removing my hd's. Am thinking there was something about having to use the dimm that's a pain in the ass to get to though if you are just using one stick of ram. However, each move I made produced different codes on the board, c1, c3, among some others...some all numbers. I don't have my book up here to check the codes, so I don't remember what they mean and epox website doesn't have a posting of them that I can find. Any more suggestions? I've been looking at other mb's just in case...thoughts on the ASUS NF7? Or the Gigabyte 7N400L? I'm not looking for much on oc'ing...more just want something I can toy with a little bit but most of all that is very stable.
 
I get this all the time when ever I try to push mine farther than I should. And I was alos really comfused to as of why it would not boot after clearing the cmos. It took me a while to figure out but it works, for me at least. Clear the cmos, and leave it in the clear position. Then unplug the computer from the wall. Leave it like this for 5 minutes. come back, plug it back in. Then 20 sec later, put the cmos pin back in it's normal position. Then, for me, all is well, hope this helped...later:)
 
C1 and C3 are generally RAM problems.

Clear the CMOS, see if that helps. If it doesn't, try new RAM.

If that doesn't help, get an Abit NF7-M :D
 
Back
Top