Need help booting up my computer

veloxity

n00b
Joined
Jul 6, 2007
Messages
22
Hi. I'm getting the following errors when I try to boot up my computer:

CPU Fan Error !
CMOS Checksum Bad
USB Device Over Current Status Detected !!
Computer will shut down after 15 seconds !!

I had this problem after I moved all my computer parts into a new water cooling case. The first time I moved my stuff into the water cooling case I booted up my computer no problem but I had to take it apart and remount it again because I had to redo the thermal paste on the heatsink and redo the tubes. Now I got the tubes running fine and now I happen to run into this problem.

Motherboard: A8R32-MVP Deluxe
 
Maybe a short somewhere? Disconnect all USB devices but your keyboard and see if you get the overcurrent error. Use the reset jumper to clear your CMOS too.
 
Short curcuit? I tried sharing some plugs because there wernt enough for the fans. There was only 2 free plugs and the water system used 2 plugs and i have 3 other fans to connect :mad: . If I did short it do I need a new power supply? And how do I fix the CPU error? I only had keyboard pluged in which is a USB plug
 
Yes! Thanks a lot for the help. I can boot up my comp now but i still get:

CPU Fan Error!

How do i fix this?
 
you said the fan wasn't plugged in? getting it working would solve the problem (most likely)
 
"CPU FAN ERROR" probably means there's nothing connected to the header on the motherboard that is normally used to power the stock (and many aftermarket) HSFs. If your watercooling system has a pump speed monitoring lead (a 3 pin fan header with only one yellow wire, normally) connect it to the CPU fan header on the motherboard if you can. If you can't (it's too short or there's no such lead), connect any fan capable of connecting to that header and see if the problem stops. There may also be a way to disable the warning -- it means nothing since you're using watercooling, but in a stock system it would mean the fan had failed, hence why it's such a 'big deal' to the system.

What brand and model PSU do you have? If you're running out of molex connectors you should probably look in to buying a quality higher rated unit, since the one you have may be overtaxed or working at near capacity all the time (not good for it).
 
Back
Top