NEC 3520a Will not Burn selected DVDs

schultet

n00b
Joined
Feb 13, 2005
Messages
8
I am having trouble with my New(egg) NEC 3520A DVD/RW. I receive an operating system error message when attempting to drag and drop or copy any data to the drive. I have had success writing with only the 2x or 4x RW but no 4x -R or +R media. I was wondering if could possible be a driver issue. I cannot find a driver at NEC or anywhere else on the web that is a freebie. The device is configured and working properly according to device manager. Attached to prmary IDE controller 0 on ASUS A8V Deluxe using VIA and 4in1 drivers.

Any suggestions whould be appreciuated
 
I was able to drag and drop a folder to the DVD/RW device (Drive D:} after re-boot this morning. I then deleted the folder to be copied from the window. After that D: would not allow any other drag and drop copies. Upon rebooting again I received a pop-up balloon from the systray indicating there where files to be written to the CD (remember I had deleted the folder previously). I clicked on it and the CD Writing wizard fired up. Requesting to Insert a Writeable Disk to Copy To. Upon inserting a 4x+RW, a 4x-RW and 4x-R and a 4x+R the same reply
----Disk is not writeable CD or it is full. I checked the RW disks and they were empty. I erased them again for good measure.
--- I elected to delete the files waiting to be copied so the CD Writing Wizard would close out.

--Next I tried to drag and drop that folder onto D: again and recevied the usual PROBLEM COPYING message. WINDOWS encounterd a problem trying to copy this folder ..... R-S-C.

Skip or Cancel to close out dialog box.

Displaying any of these DVDs indicated that there is no data on them.

Seems to be some sort of intermittent error. perhaps the drive is simply defective. Too irregular for media , OS or driver error? whaddya think?
 
Personally I just use nero and don't mess with the flaky Windows cd/dvd burning junk.

==>Lazn
 
Yes I had successfully formated an RW with Nero InCD. But the problem began when trying to use Pinnacle studio to burn my video project to this DVD Burner. Pinnacle could not successfully copy to this device, so I backtracked to windows to see if it was an OS problem and that is where I am right now.
 
Back
Top