Mystery sata ports?

Deadsexy

Limp Gawd
Joined
Sep 9, 2004
Messages
354
I got an old PC from work that I want to use as a file server and I just noticed it has 2 sata ports labeled sata1 & sata2.

I cant find settings for them in bios however and the PC wont detect a drive connected to either of them. I have been all over google but cant find anything about it.

Does anyone know how I can enable these or if its even possible at all?

The PC in question is as follows

Compaq Presario SR1200NX
AMD sempron 2800
1gb ram
what looks like via chipset of some kind lol

any help is greatly appreciated
 
I believe when SATA first came out, even though it was mounted on the motherboard, it was considered a seperate scsi device. You have to get into OS installation, then install SCSI drivers, in order to detect them. The motherboard desn't have access to them because it's the equivalent of having a raid or scsi card plugged into an expansion slot.

I'm not 100% sure on this though.
 
Further to that - some early SATA controllers just required the BIOS setting for the device to be SCSI. Dell did this. The controllers had some sort of BIOS level device drivers similar to the old SCSI controllers. If you tell the BIOS it's a SCSI device, it would execute the code on the controller.

You may still need the drivers for the OS.
 
I tried installing some raid drivers I got from hp.com but no luck. I have also been unable to find any mention of the drive or controller in bios.

any ideas?
 
I do but I cant find any settings for it in there lol.

Here is what I got

plug and play OS
reset configuration data
primary video adapter
ps/2 mouse
onboard 1394
usb legacy mode support
onboard lan
onboard lan boot rom
local bus ide adapter
onboard video memory
onboard audio
supervisor password
user password

I/O device configuration(with settings for only serial port and parallel port)
hardware monitor


strange. Starting to wonder if perhaps a cheapo sata controller card will get me the same effect/performance at half the headache? lol


EDIT: I have also updated all my drivers and BIOS to the latest I could find in case anyone is wondering
 
after some digging around inside the case I discovered that the motherboard inside is an asus A7VBX-LA

Apparently it was made by asus for compaq/hp and thus asus doesnt support the board or at least it doesnt support drivers/bios as far as I know.

I've been googling different search terms and what not with no luck. Anyone have any ideas?
 
Most likely (as already said), the BIOS will know nothing about the controller, and as such will have no options to control it in setup. It'll just appear to the system as an add-on card with it's own BIOS routine that's initiated when you set the boot-order to SCSI, if it can boot to it at all.

EDIT: I looked up the board, and it has a VIA 8237 southbridge. The 8237 has an integrated SATA RAID controller that has to be enabled by the BIOS. It's possible that HP used the board in multiple systems and configured the BIOS for your to not use the controller.
 
I had the same issue with a Compaq and resolved it by removing the cmos battery for some minutes, after that, load bios defaults and it detected the new sata disks without problems
 
I'm going to try removing the cmos battery I suppose but that seems like kind of a hail marry that shouldnt work lol.

So if HP/compaq didnt configure the bios for my system to use the card how might I, assuming its possible at all, go about getting a bios that will allow me to configure it? Possible to flash it to a VERY similar revision of the bios that will work or perhaps some magical custom bios somewhere?

So am I up shits creek or do I need to just go search in another direction on this one ya think?
 
I'm going to try removing the cmos battery I suppose but that seems like kind of a hail marry that shouldnt work lol.

So if HP/compaq didnt configure the bios for my system to use the card how might I, assuming its possible at all, go about getting a bios that will allow me to configure it? Possible to flash it to a VERY similar revision of the bios that will work or perhaps some magical custom bios somewhere?

So am I up shits creek or do I need to just go search in another direction on this one ya think?

Asus makes the boards to HP's needs, so it's just slightly different than their retail version. By flashing another BIOS in place of HP's, you'll almost definitely brick the board.
 
I think you've misread the board's model number. I can't find a A7VBX-LA on HP's site, but I did find an A7V8V-LA.
Try these drivers in Windows XP. If the SATA function isn't disabled, any drives connect to the sata ports should show up in the disk management console.

http://h10025.www1.hp.com/ewfrf/wc/...4480-1&lc=en&dlc=&cc=us&product=436281&os=228


Here's the page for your system's (and others) motherboard
http://h10025.www1.hp.com/ewfrf/wc/document?lc=en&cc=us&docname=c00069442&dlc=en&product=433683
 
On the web, there are references to both A7VBX-LA and A7V8V-LA, so be careful with assuming there's a misread or that the BIOS is interchangeable.
 
On the web, there are references to both A7VBX-LA and A7V8V-LA, so be careful with assuming there's a misread or that the BIOS is interchangeable.

But HP's site has no reference to an A7VBX-LA. I thinks it's simply people misreading the 8 as a B and going with it (which is understandable since the silkscreen does look like a B. Even the motherboard specs linked to the model number he listed says A7V8X-LA.
 
Those references are specifically to HP/Compaq computers. I'd say "assume nothing" is the way to go here.
 
Removing the battery will only fix a problem if there is a setting that is wrong in the bios. If you don't find anything then there probably isn't.

First, see if there is a way to turn off the post splash screen. Afterwords, when you boot, you see something like (I think HP is F2 for bios), is there like, F6 or F9 for scsi/raid setup? If so, use that menu and see if you can configure it.
 
Back
Top