multiple hdd's on one chip...

SnapCat

n00b
Joined
Mar 18, 2004
Messages
8
ive got an abit it7 board, so thats got the ata133raid chip in it in addition to the 2 ports of ata100. ive got two hdds in the raid chip right now, and theyre not raided, and one in the other chip. all three are bootable hard drives, and i switch between win98se (ata100) and winxp (ata133raid). now, the third hard drive is also win98 and its in the raid chip also, but when i tell the board to boot from the raid chip it defaults to the xp hard drive, or maybe its selected to do that, and this just occured to me because im about to get a fourth hard drive onto which ill put winxp, and ill put that also into the raid chip. i will want this new drive to be the default to boot off of, but since theyre all in the same chip that the bios only recognizes as "ata133raid" rather than individual hard drives like hdd-0 (which is the other win98), hdd-1, etc, im wondering how i tell the board which of the three hdd's on the chip to boot from, and i guess how i maybe already told it which of the two present hdd's to boot from...
 
1) Capitalization
2) Run on sentences
3) Spread it out into sections: config, problem, your ideas on how to solve it or your questions.

Check the bios on the raid controller to see if it can support single drive booting.
 
Back
Top