MSI KT8 Neo2 FIR problem

Ratzap

n00b
Joined
Oct 4, 2004
Messages
3
I finally got all my new machine bits in one heap and built the machine up. Much to my horror - she no worky :confused: I wrote to MSI's support via their webpage but I've not even received an acknowledgement yet so I thought I'd see if any of you have heard similar problems. This is what I wrote them:

When powered on, the system displays a graphic splash screen with "Core Cell - extreme chip you need". It will not respond to keyboard input (caps/numlock don't work either). Sometimes after 2 or 3 minutes, it will continue to a boot screen showing the bios version (ami 3.0, 6/7/2004), the processor correctly identified and the RAM also correctly identified. It lists no SATA or IDE devices and continues to ignore all keyboard input.
Waiting some more minutes, it will go to the promise raid screen and sit forever looking for devices. However, the cap/numlock now light when pressed so the keyboard seems to be responding (cnt-alt-del also works at this point, it doesn't before it).
I've tried disconnecting/removing all but the CPU/memory - same result. I tried an older graphic card from another machine - same result. I tried clearing the CMOS - same result.
Is the motherboard defective?

Processor is an Athlon 64 3800+
Memory 2 (or 4) sticks of Corsair TwinX1024-3200XL Pro

Rest is irrelevant since I've tried it with everything out or disconnected... The only things I've left to try tonight are checking the rear bracket LEDs and trying it with the MB out of the case (short circuit check).

Thanks in advance.

Wayne
 
MSI finally replied but all I got was this stock answer:

Please be sure to verify all other components in another working system
board to determine the cause of the problem.

It could be the memory controller on the processor has problem or might be
other components.

Please also try with the bare minimum components installed and retest:

http://www.msicomputer.com/support/sup_tshoot.asp

Obviously they didn't even bother reading what I sent them. And for extra fun, the reply address on the email doesn't work or their email is down.

Any ideas?

Wayne
 
I got another board sent and now the PSU isn't working. I've tried it as it should be and just with the case essentials and an old HD as a sample load - no fans turning. No nothing.
So I email Antec yesterday and no reply. Email again today and try to force some sort of return.
Damned frustrating, I got a pile of expensive kit sitting around doing nothing while various customer support mules get around to doing something.

Wayne
 
Back
Top