MSI big bang PCI-E configuration help?

Xenozx

2[H]4U
Joined
Jun 16, 2004
Messages
2,127
OK, so I am looking for a X-58 1366 board that does 2 things.

1.) Runs turbo mode on a i7 920 on all 4 cores 24/7 (my current P6T v2 does)

2.) will allow me to run 2 480 GTX's @ 16 x mode, while having 2 1x sound/nic cards installed as well.

So I found the board below:

http://hothardware.com/Reviews/MSIs-Big-Bang-XPower-X58-Military-Style/?page=5

THis board seems to be on point, until i read its PCI-E SLI config chart. It is very confusing, and I dont know if this is refering to videocards, or just add in cards all together. If its refering to add in cards, then my 2 480's will be running 8x 8x and that is not acceptable, even though i know there would be minimal loss. Can someone confirm if I can run 4 cards in 16x 16x 1x 1x mode?

SLIGPU.jpg


I was looking at the Asus SaberTooth, but very little info about it out there, and not sure why its so cheap. Like the board above cause its 16+2 instead of the 8+2 on the sabertooth. I know again that wont make a huge difference, but I like having the 16+2 if i had the option.
 
It means everything will be running at X8 speeds, if Im reading correctly. For your 4 devices.
 
The way I read it is any card in a slot is going to use up all the lanes for that slot. So any 1x card is going to use 4x lanes at a minimum. So if you put two video cards in, plus two other expansion cards, will drop both video cards to 8x, and the other two cards to 4x.

Here's a thread over at MSI Forums asking almost the same question. XPower Big Bang PCIe Lane Allocation

The short answer is no you can't.
 
That is really retarded, and quite a useless board.

atleast my current board has 3 PCI-E 2.0 16x slots, and if I use all three its 16x 16x 1x.

Guess I will have to find a board with

2 PCI-E 16x slots

2 PCI-E 1x slots

that I can use all 4 at the same time :)
 
Back
Top