Modding case for 120mm fans, quieting pc

-Sn1PeR-

2[H]4U
Joined
Dec 26, 2002
Messages
2,950
I'm looking for pictures of towers modded for 120mm fans. I'm trying to quiet down my system a bit (already using Zalman hsf for cpu and fanless for my gpu). I have 4 80mm fans (2 in the front and 2 in the back) on a reostat that has them running at I think ~5Volts. My TruBlue powersupply has 2 built in 80mm fans. There are also 2 fans built into the motherboard, but with the propper config in the Abit utilities I can run those fairly quietly. I really want to lay in some sound deadening and mod the case for 1 120mm in the front and 1 in the back. What kind of padding do you all use for sound deadening? I need to put something in front of the hole in the window (fan spot) too.

Any pictures or advice would be great. I looked alot into building a duct type system for cooling, but that's mainly for the cpu, which is being kept very cool by the Zalman HSF. Would ducting be a viable option for cooling my raid array and other storage drives while keeping the noise down?
 
As far as using 120mm fans...if you can make them work (hope you have a drill and a dremel) they will quiet the system down greatly. But for pure aesthetics and manhours invested, buying something like a Sonata or Chenbro (or any other case with 120mm fans from the factory) may be a better course.

Sound deadening material is fairly easy to find. From what I've seen, people use the spray on truck bed liner, some buy dynamat, and some get something called peel-n-seal (I use peel-n-seal). Peel-n-seal are essentially the same materials, excpet peel-n-seal is much cheaper (go to a Lowe's, its in the roofing materials section, it comes in rolls). Does a decent job of sound dampening; but be careful while applying, as it is very difficult to remove once it has been applied.

For the dusting system. Personally I found using foamboard (available at most hobby/craft stoers (ie Hobby Lobby, Michaels, Garden Ridge, et cetera) is a better alternative. Just be sure to have an exacto knife, time, a ruler, and patience. I found the results for my foamboard scheme exceeded all of my expectations.
 
Back
Top