Mobo not recognising Primary IDE Channel

The Chosen One

[H]ard|Gawd
Joined
Feb 4, 2001
Messages
1,290
Hi guys, im just putting together a cheapo Fax server for work, and ive run into a rather odd problem. When i have the HDD and DVD connected to the Primary IDE Channel...BIOS wont recognise them, but when i connect them to the Secondary IDE Channel....works fine.

Anyone got any ideas how to fix this? or is it just a faulty mobo?
Also, if its unfixable, how marked is the performance drop by running your primary HDD on the secondary channel?
because if its not too bad i really cant be stuffed returning it to the wholesaler cos it will take them weeks to sort out the problem, and ill only get a credit back after it all anyway, just too many hassles.

Here are the specs:
Abit KV-85
Sempron 2800+ s754
512mb DDR
D-Link Fax/Modem
D-Link DMT-530T Gb Lan Card
Lite-On DVD Reader.

Any ideas? thanks in advance guys
 
Make sure the jumpers on both the hard drive and the DVD are set to master/slave respectively if you are putting them on the same channel. Does it work if you put one device on its own channel? That how I set my computers up, it gives you the best compatibility and expansion possibilities.

The performance won't decrease much (certainly not noticeably) if you move them both to the secondary channel. Again, make sure that all jumper settings are correct or the mobo won't detect any of the drives.

Good luck!
 
yeah all jumpers were setup right, and it didnt work with single or both drives on the primary channel in any configuration. Worked perfectly on the second channel, but i still thought i better not be dodgy, and just RA'ed it.

Left my house at 4:50pm...spent 35mins in traffic before arriving at the place at 5:25, thankfully they quickly tested it and swapped it over in 5mins, so a replacement in time for the weekend.

THanks for the reply and suggestions.
 
Cool, thats a good solution there. The 35 minutes in traffic was worth it then :)

Glad to help!
 
Back
Top