Mobo/Memory Combo

Joined
Jan 12, 2007
Messages
6
Hey all,

I have an ignorant question about newer RAM and an older mobo.

I have this Mobo: http://pixel01.cps.intel.com/products/motherboard/d945gtp/index.htm
which says it will take up to DDR2 400 MHz DIMMs.

and this memory: http://www.newegg.com/Product/Product.aspx?Item=N82E16820145033
which is DDR2 1066 MHz

they match up in that they're both 240-pin DDR2 SDRAM.
compatible?

i know the MHz doesn't match up but i wasn't sure if RAM was backwards compatible in that it would work but underperform to the Mobo's highest ability. or would it just not work at all?

thanks!
 
the board supports ddr2 667 533 400.. its not worth spending the extra money on 1066 if you plan to use that system for a while.. the fastest the memory will run is ddr2 667.. then the question comes up as far as the board even supporting that memory..

i would just stick with getting some cheap ddr2 667 if you really need more memory.. if not then wait until you upgrade to a newer system before buying higher speed ram..
 
well the reason i ask is that i have that memory just lying around collecting dust.
a friend of mine has an older computer that could use the extra memory.

even if the board ran the memory at a much slower clock speed at least it would be more memory.
whether it would run it at all is the question.
i don't want to ruin any hardware trying it without gathering some opinions first.
 
i would give it a try worst case it would not work, personally i have a feeling that it will not work
 
well the reason i ask is that i have that memory just lying around collecting dust.
a friend of mine has an older computer that could use the extra memory.

even if the board ran the memory at a much slower clock speed at least it would be more memory.
whether it would run it at all is the question.
i don't want to ruin any hardware trying it without gathering some opinions first.


if you already have it.. then yeah, go ahead and try it.. i thought maybe you were planning to buy it.. you wont damage anything.. either it boots up or it doesnt.. if the screen doesnt come on when it boots up.. then they wont work... just make sure you dont turn it off right away.. wait 5 seconds or so.. then shut it off because the systems still booting in the background.. if you shut it off to soon you have a chance of corrupting the bios, even though its unlikely.. its a possibility..
 
thanks for the input.
i'll give it a try and see what happens.
probably should find out how to reset the bios before i do :)
 
Faster-speed RAM will run at lower frequencies without a problem. It is only when you try running slow RAM at higher speeds that you may have issues.
 
Faster-speed RAM will run at lower frequencies without a problem. It is only when you try running slow RAM at higher speeds that you may have issues.

true for the most part.. except my kingston pc-3200 1GB hyperX ram.. :p theres only 3 options set in the ram for default speeds.. ddr 333 ddr 400 3-3-3-12 ddr 400 2-3-2-12.. it refuses to run anything under ddr 333..
 
finally got around to installing the memory.
it worked without a problem.
thanks again for the help.
 
true for the most part.. except my kingston pc-3200 1GB hyperX ram.. :p theres only 3 options set in the ram for default speeds.. ddr 333 ddr 400 3-3-3-12 ddr 400 2-3-2-12.. it refuses to run anything under ddr 333..
Probably an issue with the memory controller rather than the RAM. A friend of mine used to run HyperX DDR1 sticks and he had no problem running them under DDR333 speeds (although he didn't often do so).
 
Back
Top