mild oc with software?

Joined
Jun 6, 2006
Messages
1,001
I know it's typically frowned upon, but using the gigabyte motherboard utility (easytune 5) i upped the FSB a bit until i got my AMD 3000+ Winchester up to 2.0ghz.

i've run prime95 for 3 hours, and temps are staying at 35C.

should i leave it, or end my silly little foray into OCville?

zv
 
If you liek it leave it there but I would set it in bios instead of using software(if you can)
(might be a bit more stable and its something less your computer will havde to load at startup).

Congratulations btw.:)
 
yeah i noticed my boot times were much longer. I set it back.

I'm going to do a little more reading on the AMD OC FAQ sticky. the only thing i didn't understand was using windows based clockgen software to adjust freq.

i thought typically, people felt pretty strongly it should all be done in the bios.
i guess i just figured i'd need to adjust in bios, boot into windows, check stability, reboot into bios, adjust, boot into windows, check stability etc etc etc.

zv
 
so i upped the CPU bus to 220 from 200 at a 9x multiplier (1981mhz) i'm 2hrs into prime95 w/ no errors. 1.45v insteak of 1.4v stock, and temps are steady at 34C


one thing i noticed is that in task manager, my page file usage is much higher than normalduring the prime run. It's usually below 500MB, but right now it's at 1.17GB. is that a sign my memory is maxed?

mem settings are stock (factory reccomended settings) and the HT multiplier is set to auto. mem divider 2/2.

what's my next move?

this is rig 2 in sig.


zv
 
Back
Top