• Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
    Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.

Mem issue after watercooling installed

Y

Yahhoun23

n00b
Joined
Nov 9, 2005
Messages
4
I installed my swiftech Ultra+ Kit this week and today finally had it all done.

I re-installed everything, and turned on and now get three long beeps.

Apparantly something has gone wrong with my memory.

My question is, is there any chance it's not memory related? I re-checked the memory and re-installed it into the slots, and still same long 3 beep error.

I just don't want to have to go out and buy all new memory if it could be another card or something. I assume it couldn't be because of the error beeps I'm getting, but wanted to confirm. It worked fine of course last week before starting this project, but you know how that goes.

Anything I can try before spending money on new mem?
 
i find that every time i have gotten the "rambulance" tone it was not directly related to a problem with my memory.

in my own case i usually ended up fixing the issue by using trial and error to find the correct sequence to clear the CMOS, put one stick of memory in, power on (sucessfully) then shut off and install the second stick.

it's really aggrivating and i had to work it out pretty much any time i took the memory or proc out of my old DFI board...........good luck.
 
You must log in or register to reply here.
Back
Top