MegaRaid SATA 150-4 Drive Problem

Joined
Dec 17, 2010
Messages
3
I have a MegaRaid SATA 150-4 with 4 Samsung HD154UI drives in a RAID 5 configuration. It had been in service about 6 months. The RAID card reported 1 drive had failed. I ran SeaTools on the drive, it came out clean. When I try to rebuild the drive into the array, I get a drive is a different size error in the Power Console. In the CTRL-M config, I get not responding. I believe the card might be reading a partition error. I don't think I have ever tried to format the drive under NTFS. The computer is using XP as an OS.

Is there a utility to reset the drive back to a unformatted state?

Thanks
 
Have you verified that after plugging the drive back in the machine that has the raid card that the drive spun up?
 
No I have not.

The computer will be busy for a few days rebuilding the new drive. I will check that soon as it is completed.
 
Rebuilding the new drive? Confused, you mean you bought a 5th drive or is it now accepting the old drive.
 
Is there a utility to reset the drive back to a unformatted state?

Thanks

assuming from within windows, or otherwise at a windows command prompt....

in command prompt, type "diskpart"
type "list disk"
select the drive that you want to erase ("select disk x" where x = drive number)

*make sure this is the drive you want to erase*
type "clean" (if you want to zero all sectors on the disk, type "clean all")
your computer will now see this drive as if it were brand new unformatted.
 
Back
Top