mb switch ok when different chipsets?

bbxrider

n00b
Joined
Nov 18, 2009
Messages
4
looks like my asus p4p800 mb got blown out when i accidentally hit the off
switch on the surge protector when pc was running. I have checked the power supply
with my vom and on another pc, it checks out. the p4p board power light is on but no response to the on/off sw, which i also tested with my vom

the p4p has intel 82865pe + ich5r. the replacement board i'm thinking of is an intel d865glc, with an 865g chipset which is 82865g and ich5. these boards are both socket 478 so i can reuse my p4 processor.

i'm hoping i can plug in my current c + d ide drives, where i have winxp pro installed,
primary on c and a backup on d and the system will come up? there's a sony dvd/cd rw drive f, i also have a sata drive which i suspect will come up ok, its drive g on the old system

is this all possible? i have about 30 programs installed so it will be quite a
bit of work to duplicate if i can't get the current system to come up on the new board. all my data is on the sata drive, so i'm hoping i will be ok with that
 
Yes it is possible even though people will try to tell you otherwise.

My current XP partition is the same installation that has gone from an AMD XP on NF2 to an AMD 64 X2 on NF4 to a C2Q on P45. I have never performed a format or repair installation on it.

Boot into safe mode and have all the drivers handy. Sometimes it helps to have a PS/2 mouse handy to click on the driver installation prompts because if Windows doesn't have drivers for your new chipset, the USB will be nonfunctional. Ideally I would have all the drivers I needed laid out on the desktop first but if you have to get them from CD, go ahead and do that. If your XP install is already SP3, that would make things easier since more drivers are available and included already.

Worst case scenario, do a repair installation from the CD and it will keep your installed programs intact.
 
Last edited:
thanks for the replies, so as xp boots on the new board it will realize it needs new/different drivers and ask for them if it can't find them automagically? at this point i don't have any idea where they would be either? if i boot safe with networking, with any luck i can get them from the net after dodging all the fake out stuff that comes with that.
been reading a quick bit on sysprep, dont' see how i would use it in this instance? i have my one old 'image' on my current disk, i'm trying to get that copasetic with chipset(s) on the new mb, if that takes new drivers, then ok, hopefully it will be clear what is being sought and then that i can find them and get them available to xp, even if plugging a usb mem stick. sysprep sets up to copy a master image to new pc? i would need xp running ok to run sysprep in the first place?
 
thanks for the replies, so as xp boots on the new board it will realize it needs new/different drivers and ask for them if it can't find them automagically? at this point i don't have any idea where they would be either? if i boot safe with networking, with any luck i can get them from the net after dodging all the fake out stuff that comes with that.

You won't have any network if the network chipset doesn't have drivers either unless your system already has them and recognizes it.

Just use a separate computer and download all your drivers first and burn them to a CD or copy to a floppy. Your USB drivers might not work either so don't rely on memory sticks.
 
Back
Top