machine_check_error on boot?

Dr. X

Supreme [H]ardness
Joined
Oct 27, 2000
Messages
7,060
Alright, well, I've been working on ocing the comp in my sig, and ran across some problems. I had it up to 240 fsb and at that point it starting giving me application errors in windows, such as from firefox, explorer, etc. So I kept rebooting increasing the vcore by small increments to get it stable but couldn't. After some attempts, it starting giving me a bsod on boot with a machine_check_error. I couldn't get it to boot at all, even in safe mode and after resetting the bios to all default values. It only finally booted after pulling out the cmos battery and letting it sit. So, I'm wondering, why did I have this problem? Possibly memory timings, or vcore too high? I only got up to 1.55 volts which, for a 3200+, should be ok, right? Any ideas here guys? The settings I was running were:

240fsb vcore up to 1.55v
mem 1:1 2.5-2-2-5 1T 2.65v
HT 4x
 
Dr. X said:
Alright, well, I've been working on ocing the comp in my sig, and ran across some problems. I had it up to 240 fsb and at that point it starting giving me application errors in windows, such as from firefox, explorer, etc. So I kept rebooting increasing the vcore by small increments to get it stable but couldn't. After some attempts, it starting giving me a bsod on boot with a machine_check_error. I couldn't get it to boot at all, even in safe mode and after resetting the bios to all default values. It only finally booted after pulling out the cmos battery and letting it sit. So, I'm wondering, why did I have this problem? Possibly memory timings, or vcore too high? I only got up to 1.55 volts which, for a 3200+, should be ok, right? Any ideas here guys? The settings I was running were:

240fsb vcore up to 1.55v
mem 1:1 2.5-2-2-5 1T 2.65v
HT 4x

It is the 1t setting FOR SURE. I cannot increase my 1:1 beyond 239.6mhz at 1t.
 
Back
Top