I've got my new server up and running, but my drive speeds seem a bit slow. I've never used an LSI raid card before and there are tons of options, so I was wondering if anyone had any advice as far as how I should look at the settings. I have the LSI MegaRAID SAS 9260-16i card. And using the Norco 4220 case for a SAS backplane.
I currently have the following setup:
1x 1TB SATA drive plugged into the motherboard for the OS.
7x 2TB SATA drives plugged into my LSI MegaRAID Card for storage in RAID 5.
When I transfer a 7GB file from the OS drive to the storage Raid, it starts at about 40MB/sec, and then drops down to 10MB/sec for most of the transfer.
I'm using the same drives that I was using on my old Dell Perc raid card, but I'm not sure why this new card is so slow. So I'm guessing there are some settings somewhere that I need to configure to help this. There are tons of settings, and I'm not too sure about any of them since I'm a novice with the card.
I currently have the following setup:
1x 1TB SATA drive plugged into the motherboard for the OS.
7x 2TB SATA drives plugged into my LSI MegaRAID Card for storage in RAID 5.
When I transfer a 7GB file from the OS drive to the storage Raid, it starts at about 40MB/sec, and then drops down to 10MB/sec for most of the transfer.
I'm using the same drives that I was using on my old Dell Perc raid card, but I'm not sure why this new card is so slow. So I'm guessing there are some settings somewhere that I need to configure to help this. There are tons of settings, and I'm not too sure about any of them since I'm a novice with the card.