Loop Question

[W.Feather]

Working on putting my loop back together, looking for suggestions/answers to my questions

1) I have monsoon compression fittings, they have two sets of o-rings in the packaging, why? I have only used barbs peviously so i dont know what to do with the 2nd set (I put one of em on the bottom of the barb lol, didnt seem to harm the compression at all, should I remove it? )

2) Trying to figure out the best loop setup, I dont think it will take much of an difference and going for the easy way would be smartest, the rad is an RX 360 with 6x AP-15's on it.....I have the XSPC Rasa CPU block, 2x Alpha Cool 6970 blocks (in parallel, see picture), and the block on my board.

Thinking of doing: Pump/Res -> CPU -> GPU -> Board -> Rad -> Pump/Res ... thoughts? Looking for quick thoughts if possible


Thanks,
-W.Feather


Edit: Forgot to add the loop/board as it stands

[IMG=http://img5.imageshack.us/img5/8383/20130308221933.jpg][/IMG]

Uploaded with ImageShack.us

 

[Tsumi]

You would be correct, loop order doesn't really matter and just configure it the easiest way you can.

You should only use one o-ring at a time. Two might create some unforeseen complications, like gaps between the rubbers, etc.

 

[W.Feather]

Ya i see, got it running a leak test now


IT is a PITA to fit everything in an Antec 1200....not a very friendly case for this i must say ... cant wait for a new case later this summer......had to moutn the rad and half the res/pump external lol nothing some [H] modding wont fix