LAN problem: faulty motherboard?

Shocked

Limp Gawd
Joined
Nov 1, 2009
Messages
373
First off, two months ago there was a flood in my house that originated from the bathroom next to my home office while I was out of town. It looked like my computer came out of it unscathed except for some cosmetic damage on the very bottom of my case (an NZXT Switch 810), although now I'm not so sure, especially considering it was sitting in a very humid environment for at least a few days. Immediately after coming home I moved into temporary housing, which is when this problem began.

Often times (not quite as frequently lately but still happens) when I plug any devices into USB (both case and motherboard ports), the light on the ethernet port on my motherboard will go out and I'll lose connection immediately until I unplug it and plug it back in (sometimes having to go the extra step by fiddling around with it a little on top of all that).

I can't replace the ethernet cable where I am currently because it goes straight into the wall (rather than plugging into a wall socket). Before I run out and buy a LAN card, could that kind of thing be attributed to a bad cable to begin with or is that definitely a motherboard issue?

With everything been going on there's been so little time in the day to troubleshoot or get anything done in general, just wondering if anyone could point me in the right direction.

4770k | ASUS P8Z68-V PRO/GEN3 | 2x 8 GB DDR3-2133 | GTX 1080 | Corsair AX1200 | NZXT Switch 810
 
If the cable became damaged (slightly crushed, insulation broken) and then water got into it, then it can be root of the problem. Maybe a nearby run of AC is also leaking power out into the now humid wall.
Can you try another Ethernet access point? If the computer still does that, then it's the mobo or PSU.
 
If the cable became damaged (slightly crushed, insulation broken) and then water got into it, then it can be root of the problem. Maybe a nearby run of AC is also leaking power out into the now humid wall.
Can you try another Ethernet access point? If the computer still does that, then it's the mobo or PSU.
I'd try another access point if I could, but my options are limited where I'm currently staying.

I should probably point out though, while my office was very humid, the computer was off (albeit plugged into an outlet) when all this occurred, I didn't even attempt to power it back up until I got it out of there.
 
I'd try another access point if I could, but my options are limited where I'm currently staying.

I should probably point out though, while my office was very humid, the computer was off (albeit plugged into an outlet) when all this occurred, I didn't even attempt to power it back up until I got it out of there.

Then I guess you could still try another computer or at the least a laptop on that particular outlet. Or put a switch in the between.
A proper cable tester can also show if there are no shorts between individual wires.
Other than that, you're left with a shot in the dark by buying a discrete interface or motherboard.
If it was plugged in then sadly that counts as powered on in water related situations. Standby voltages and the ability to short out the standby circuit or get high voltage out to the secondary.
 
On-board NICs are cheap and usually can be disabled in the BIOS. I've had one flake out after a power outage. Grabbed an Intel NIC from local shop and moved on. Still humming along fine to this day.
 
On-board NICs are cheap and usually can be disabled in the BIOS. I've had one flake out after a power outage. Grabbed an Intel NIC from local shop and moved on. Still humming along fine to this day.

I was going to say exactly the same thing. :)
 
Back
Top