![[H]ard|Forum](/styles/hardforum/xenforo/logo_dark.png){kind=logo}
- Joined
- Jul 11, 2001
- Messages
- 12,842
Unfortunately due to my motherboard layout, my 2nd 4870x2 blocks half of the SATA ports on my board. Because of this I have a PCIe 1x JMicron 363 2-port SATA controller installed and I have a 500gb and a 1TB drive attached to that.
However I noticed that when one of the drives comes under heavy disk access, my computer would pause for a few seconds randomly. I checked the event log and there are endless problem entries regarding this drive/controller.
There are two repeating errors:
An error labeled Disk:
The driver detected a controller error on \Device\Harddisk1\DR1.
An error labeled JRAID:
The device, \Device\Scsi\JRAID1, is not ready for access yet.
Any ideas how I might solve this problem or is it simply due to the JMB363 controller being a POS? I can access the drive fine but the errors occur during heavy disc access, like when I open my torrent program and it starts trying to seed the 300 files I have located on that drive. This same drive never had any issues on the ICH10R.
However I noticed that when one of the drives comes under heavy disk access, my computer would pause for a few seconds randomly. I checked the event log and there are endless problem entries regarding this drive/controller.
There are two repeating errors:
An error labeled Disk:
The driver detected a controller error on \Device\Harddisk1\DR1.
An error labeled JRAID:
The device, \Device\Scsi\JRAID1, is not ready for access yet.
Any ideas how I might solve this problem or is it simply due to the JMB363 controller being a POS? I can access the drive fine but the errors occur during heavy disc access, like when I open my torrent program and it starts trying to seed the 300 files I have located on that drive. This same drive never had any issues on the ICH10R.