Is this fan actually doing anything?

Eagle156

2[H]4U
Joined
Jan 21, 2006
Messages
2,242
I have a very noisy 120mm fan that I replaced, so I decided to make it useful by sticking it on the side panel as an exhaust and slowing it down to about 500rpm with my fan only molex connectors. But the thing is that it looks rather ugly with those screws and washers on (my case has a honeycomb pattern mesh on the side) so I'm wondering if its actually doing anything? My temps have always been fine and I haven't noticed any major temp change but I'm an airflow freak. :D The fan is near the top 1/2 part of the vid card and below the cpu, so I guess it could be pulling hot air from the vid card. But it's an X1900XT with the stock cooler which has an enclosed design. If it matters, my front intake fan is 1400rpm, the rear exhaust is 950rpm, and this side exhaust is ~500rpm.
 
Below the CPU? Most likely not. It would probably be hurting your CPU temps if anything.

All I can foresee is it pulling fresh air away from the CPU. A top mount fan at this speed would be better because it would draw the hot air out as it rises, but yours is too low in the case to accomplish that.

Get rid of it. All its doing is drawing power and robbing air from the rest of the PC.

Leave the hole open and let it passively draw or exhaust air as it needs.
 
Zero82z said:
It would serve better as an intake.
QFT, dunno why I didn't think of that. Hell, why would I think of something as simple as flipping a fan around. ^.^
 
If I use it as an intake the fan blades scrape against the mesh. I guess it's going down then. :)
 
Eagle156 said:
If I use it as an intake the fan blades scrape against the mesh. I guess it's going down then. :)

why not put some spacers between the fan and the mesh? A washer or two on each corner should help. Or maybe a rubber gromet to reduce vibrations?
 
Back
Top