Is the sata cable rating important?

munkle

[H]F Junkie
Joined
Jan 16, 2005
Messages
11,799
I have various sata cables some say sata I some say sata II and others say sata III. Is it really all that important?
 
SATA II work fine at SATA III speeds. Just make sure the connectors are gold-plated on the side where you copy the most data from, and platinum-plated on the side receiving the most data, so that the electrical differential will accelerate the electrons and speed up the data transfer.

Between the connectors, the cable must be wrapped in an electric blanket set to 50°C, again for the same fast data transfer purpose.

And to be on the safe side, take extra care of organizing your data so it contains mostly bytes with a low bit weight. For instance, byte chr(256) weights 7 times less than byte chr(255) because it has only 1 heavy "1" bit and 7 light "0" bits that are faster to transfer, vs. 7 "1" bit and 1 "0" bit for chr(255).

If you still experience SATA III transfer issues with your SATA II cables, manufacturers recommend that all critical data transfer be made during full moon, so that the lower gravity will lighten the electrons and speed up the transfer, thus giving you the extra margin your SATA II cables need.

;)
 
I'm having a hard time finding an electric blanket that works well with the short (6") SATA cables I'm using. If anyone has found a good source for short electric blankets I'd appreciate hearing about it.

Also, are transfers faster if the cable is running downhill from the motherboard to the drive (here I'm talking about transfers to the drive, obviously)? If so I may need to turn my case upside down, so I hope this doesn't make too much of a difference.
 
Back
Top