Is my PSU still going to work?

tonyluu

Gawd
Joined
Dec 20, 2008
Messages
613
I was sleeving my wires individually, started with the 24-pin connector first & one of the 5v ground connectors (red) was being stubborn and would not get out no matter what, spent 1hr trying to get it out so I just pulled it out really hard and the "head" was still stuck to the header & the bare wires are now showning & I can't get it back into the hole
 
Don't want to risk the chance of frying anything, I don't have the money go get a new replacement.
 
Don't want to risk the chance of frying anything, I don't have the money go get a new replacement.

Why did you mess with it in the first place?
Every modification holds a risk, especialy if you're not sure what you are doing (pulling the cable out :confused: ????)
Now try again to remove the pin and solder it back on the wire, then continue your sleeving job
 
That's the problem, I can't get the darn thing out
Should I just get a new header & reconnect?
 
one of the 5v ground connectors (red)
Red is +5V, not ground.

Get a new header if you want, but I would advise that you give it another shot and try and get the pin out again. A small screwdriver set can be very useful for getting it out, and if that doesn't work, try a molex removal tool.
 
I did the 2 staple method with over many different sets & I have this thin sharp thingy to also help but it doesn't help on this pin
 
just get the tool online or microcenter if you have one near you. makes things sooo easy
 
Back
Top