Intel SATA 2 problem actually a problem.

nimbyfaygo

Limp Gawd
Joined
Jan 18, 2006
Messages
488
I have a 1st gen GA-P67A-UD3P motherboard in my system. I received the recall info like everyone else, but I decided to wait to return it, since everything was working fine.

Today I actually noticed that I had a problem when connected my E-SATA drive and windows wouldn't recognize it. (My front E-SATA is connected to a SATA 2 port on the board.) I had it connected several times in the past without issue. Not thinking much about it I swapped drives with a known good and it wasn't recognized either. So I installed the drive directly to the SATA 2 port and still nothing.

That put me in a bit of a bind. I have a raid 0 setup using both of the SATA 3 ports. I had to go out a buy and USB 3 enclosure so I could access my backups. I went ahead and split the raid, I suppose tomorrow I'll get my RMA underway.

I am just surprised that the issue manifested itself at all. And the ports just ceasing to work, that's kinda odd.
 
Disappearing ports that you are experiencing have nothing to do with the issue on the "6" series boards. The problem with the “6” series board is that the SATA II ports is that over time the data from would become corrupted and makes any data that had been written worthless once the problem had started. In 3 years somewhere around 5% of board may have had this problem; that number is still too high for us and that it why we had all the boards pulled. If you still have one of these boards we advise that you return it and get a new from the motherboard manufacturer or the place that you brought the board from.
 
Disappearing ports that you are experiencing have nothing to do with the issue on the "6" series boards. The problem with the “6” series board is that the SATA II ports is that over time the data from would become corrupted and makes any data that had been written worthless once the problem had started. In 3 years somewhere around 5% of board may have had this problem; that number is still too high for us and that it why we had all the boards pulled. If you still have one of these boards we advise that you return it and get a new from the motherboard manufacturer or the place that you brought the board from.

You sure about that? The press release said the connectivity issues was exactly the issue, and that data loss was specifically not a concern.
 
Disappearing ports that you are experiencing have nothing to do with the issue on the "6" series boards. The problem with the “6” series board is that the SATA II ports is that over time the data from would become corrupted and makes any data that had been written worthless once the problem had started. In 3 years somewhere around 5% of board may have had this problem; that number is still too high for us and that it why we had all the boards pulled. If you still have one of these boards we advise that you return it and get a new from the motherboard manufacturer or the place that you brought the board from.

That is what I was expecting, a possible slow down over a long period of time. I honestly wasn't expecting any problem to manifest.
No matter what the actual cause may be, I now have a "6 series" board that has 4 inoperable SATA 2 ports.

It would be ironic that my ports died for a completely different reason. ;). No worries, I have an RMA underway. I should be getting a B3 stepping board in a few days.
 
Disappearing ports IS one of the possible problems on this B2 version. This was discussed at length. It isn't always just data dropouts. IC degradation can cause varying symptoms.
 
Back
Top