Intel E6850 duo running hot on water?

Grady

Weaksauce
Joined
Nov 14, 2007
Messages
70
Well, I finally got my water cooling setup and running to get CPU core temps at 38-45c on idle, which, I guess may be a little normal, but then at the slightest bit of load, then temps jump a lot over about 55c on both cores. I'm about to run Call of Duty 4 to see the temps under at actual load that I'd be doing.

I tried running Orthos to see how high they'd get and oooh man, they got high quick.

My CPU is also automatically underclocking itself at a 6x multiplier when it should be at 9x.

Do these naturally run hot? I'm pretty sure my water cooling circuit is air free and getting somewhat optimal flow, so I don't think that's it...but I could be wrong on that.

Any other ideas?


EDIT: The Call of Duty 4 temps are ~70c when playing. That's pretty damn hot. Especially for water =(
 
your watercooling is borked in some way or the temps are not correct. I would assume if you've watercooled before that the temp reporting is in error.
 
I have not watercooled before. What could be wrong with it? My Nvidia 8800GTX runs at 60c on load, 49-50c idle; which is damn good I've seen/heard so I know the water is flowing at least good enough to make that temp low.

But the CPU...I dont understand. I don't know why they are running so warm. I saw the temps on the CPU get up to 72c.

Any suggestions?

Also, why is it automatically underclocking itself? It should be running at a 9x multiplier.
 
I don't know enough about watercooling to know, sorry. Perhaps the processor is underclocking itself as an automatic measure because it would be even hotter? I don't have a core 2. I know you're going to need the help of someone who has watercooled extensively, and you're going to need clear pics of your watercooling setup to sort this out. If others can't see it, they might not be able to identify the problem.

I suspect the multi will work itself out when the heat issue is resolved.
 
Your problem is the contact between the CPU and waterblock. Did you use WAY too much thermal paste (or none)? Is it tightened down crooked so only one edge is making contact? Basically try removing and reattaching it.
 
Well, I did notice on the CPU that there was a corner with just a very very small amount of thermal paste missing, so I applied some and reattached it. Same temps.

I ran Orthos for about 15 minutes and it took my CPU temps to ~85c which, the E6850 is only rated for 75c. So, I believe that may indicate that my sensors on my motherboard are bad because the computer would have surely shut itself down at 85c.
 
Back
Top