Inline temp probe for 1/2" ID Tubing?

halcyon

Gawd
Joined
Mar 20, 2003
Messages
717
Just wondering if anyone know of anywhere to get an inline temp probe for 1/2" ID tubing? I found some excellent commercial innovatek ones (but they are 8mm), just wondering if there is something similar for 1/2", or if there is a good tutorial on making one yourself with minimal flow restrictions. And for that matter does anyone know of a good flow meter for 1/2" id tubing either?

Thanks!
 
Have been looking myself and I figure you will have to build your own. You need a standard 1/2 to 1/2 union. I'm planning on a different size and I will be using a stainless steel connector. First you need to get a standard thermocouple that is designed for immersion and this may take a while to find one at the right price (i'm still looking). Then you drill through the side of the connector and insert it with a bit of epoxy sealant. Make sure that the series thermocouple works with your display as there are several different series. IIRC a J or K series works, but check with the manufacturer of the display you want to use FIRST. Good luck and post back with your results :)

Added:

Found what you are looking for at HighSpeed PC

Also took apart one of the Innovatek sensors this AM. I will post some info to my website late today when I get my camera charged up. I first thought that the sensor screwed into the union as a unit. Being the inquisitive soul I am I also decided to take one apart to see if I could find a part number. The copper part that screws into the connector is a simple screw machine part that has a hole in it for the standard thin sensors commonly used in computers. All they did was to insert the flat sensor into the hole and use a piece of flexible silicone? round stock to wedge it in. Then they of course added some 2 conductor wire and that's all she wrote. The part number on the sensor is: S103GR2. The "S" might also be a "5" as I am looking at it under magnification.
 
Back
Top