ideas

[ocphangaz]

my current fan configuration in my casing...

front bezel, 120mm 93CFM sucking fresh cool air from outside
5.25" bezel modded to be exhaust for the excessive air intake...

rear, 1 60mm 40CFM to suck air from outside towards the vid card
rear, 1 duct for 92mm delta 110CFM intake to CPU

PSU exhaust


so.. this been lingering in my head for few days... what if i set the 110cfm as outake and exhaust through the rear ?

currently i have system temp problem, where it'll start from 30C.. and goes up until 38C, compared to the CPU where it stays at 42C.

 

[99rollaguy]

the only thing you're using for exhaust is the PSU?

5.25" bezel modded to be exhaust for the excessive air intake...< I'm not sure I understand what you're saying here. the front of your case is acting as both an intake and exhaust?

a blowhole fan(top of case) would help quite a bit.