Ic7-max3

Joined
Jun 5, 2004
Messages
2
HI
I got this motherboard and put it in my case with everything put in but when I turn it on there was nothing on the monitor oh the fans light and everything worked in the case but nothing on the monitor do I have a bad motherboard or is there anything that would cause this, a friend of mine says it may be the RAM not compatible. Any help??

Brian
 
First remove the MB from the case, and setting the MB on the static bag that it came with, try running just the processor, video card and ram (nothing else) and see if it starts up. The reason to remove it from the case is that you may have a stand off shorting the bottom the the board somewhere. If this works, carefully reinstall it in the case (double checking brass stand-off locations) and replace the rest of the hardware one peice at a time (testing after each) till it is all togther.

Also is your video card a AGP 4x or newer card? Because if not, that may be your problem, older 5V cards don't work in newer motherboards.

Is there any beep code?

==>Lazn
 
What kind of memory do you have? I'm pretty sure the 875 chipset has compatitbility issues with certain chips.
 
I had this board still do for a short time longer. Anyways. Mount the CPU & HSF to the board and a PC speaker. Fire it up and listen for beeps if thats good install one stick of ram and video card. Then add from there. If you don't get any beeps on the first step replace the CPU if still nothing then replace the board.
 
I just went through this same thing with a friend of mine and an IC7. What happened is he ordered some adata ram for it, and when I put it all together and hit the switch... .nothing. No beeps or anything. Couldn't figure anything out. I put some old pc2700 in the board for s^%$ and giggles and lo-and-behold... it booted. Scratched my head for a few minutes, turned everything off, put in the new ram and everything worked fine. I don't know if it was a seating error or if the ram banks were holding a static charge or what, but it now works completely fine. So I suggest throwing some different ram in there first and making sure that everything is seated, because in my experience it IS a ram problem. It just may not be a compatability problem.
 
Lazn_Work said:
First remove the MB from the case, and setting the MB on the static bag that it came with, try running just the processor, video card and ram (nothing else) and see if it starts up.

powering up a mobo while it is sitting on a static bag? is that safe?
 
yeah you should set it up on the box. But if its already mounted in the case no reason to remove it unless the power supply is tripping off or it still acts dead with just a cpu on the board.
 
ewarz said:
powering up a mobo while it is sitting on a static bag? is that safe?

I have done this more times than I can count. Take a multimeter and check the resistance accross a static bag. Yes it is more conductive than normal plastic (to prevent static charge build up) but it is still very close to non conductive.

==>Lazn
 
Hi all
OK you gave some great Ideal here ok when I start up the computer I hear nothing no beeps nothing the Video is 8X AIT Radeon 9800 the ram is PC2300 512mb two of them and the CPU is intel 2.8mhz so should I put one idem at a time on the motherboard to see if they work I will try that many thanks.

Brian
 
Back
Top