Ic7 Max3 Silicon SATA Prob

Joined
Jun 16, 2004
Messages
660
I have a raid 0 setup on the first 2 ports of the SI chip. My raptors worked fine but all of a sudden, they stopped and only 1 drive is recognized now. I assumed... dead drive, but i put the "dead" drive on the ICH5R controller and it see's it fine when the SI chip wouldn't even detect the drive.

Not sure what I should do because no channel on the SI will see the supposed bad drive. Can I just setup the ICH5R as Raid in the bios and move the 2 raptor's over and the raid partition be saved? Or do I have to move them and recreate the raid and partitions? I want to save the data off the drives if possible. Any ideas would be awesome.
 
Welcome to the joys of RAID 0. your data is borked.

In general unless you are doing video editing, RAID 0 is not worth it, as it actually slowes down seek times (small file performance is worse than a single drive) large file performance is increased, this is why if you do Video editing, or large photoshop editing, it can be a help.. otherwise it is not worth the increased risk and decreased small file performance.

==>Lazn
 
I just figured with the increase in speed, the Raid 0 would work better for windows and for my games. I have a bunch of important stuff on the drives too that I need to get off. One recommendation is to try the ICH5R port since it recognizes the supposed bad drive. That is my next task, then try a Ghost utility, and if not try a Knoppix boot cd and see if I can at least get into the partition and copy the stuff off.
 
Well I would be very suprized if you can get the Intel RAID to recognise the array, and unless you can recover the array you can't get the data off the drive as it is spread across the two drives. (bit one of file one on drive one, bit two of file one on drive two etc.)

Also testing has shown that for Windows and Games RAID 0 can actually decrease performance (but usually does nothing) quote form here: http://www.anandtech.com/storage/showdoc.aspx?i=2101&p=11
"If you haven't gotten the hint by now, we'll spell it out for you: there is no place, and no need for a RAID-0 array on a desktop computer. "

==>Lazn
 
Well it didn't recognize it... lol. Basically it see's both drives and says they are bootable, but no raid array is present. I recreated the raid on the ICH5R and everything is cool... but now I try to install windows and it doesn't see the partition present... just my IDE drives. No clue whats going on there. I can unraid then and shove them in as just IDE 3 & 4 if I have to with no raid. I just want my games and windows on the raptor drive since its faster.
 
Back
Top