Ic7-max3, and a heatsink?

Z

Zecora

Limp Gawd
Joined
Sep 28, 2002
Messages
354
I am wondering if a sp-94 with fit on my ic7-max3 with a replaced northbridge cooler?

can anyone post pics of theres?
 
Yes I have the same board and I have a Sp-94 witch Vantec Tornado . Running stock northbridger cooler though it is a tight squeeze, I didn't have to worry much though when I installed it though. If your northbridge cooler is wider than the Abit stocked northbridge cooler I would have to say no.

Hope this helps.
 
Yes it fits with no problems. Would you like to see a picture? I can take one tonight when I get home!
 
yes i would love to see a pic.

My northbridge fan is taller, i ordered swiftech something.
 
here is a pic of mine

ic7-max3 w/ enermax 92mm fan
stock NB cooler
sp94_1.jpg


sp94_3.jpg


sp94_2.jpg
 
my temps are pretty high due to the fact im running a prescott. i dont remember exactly but i think its around 55 load. my WC setup is almost done though, so i hope to see a huge drop in temps.
 
that NB cooler is a bit high..... mine is very short.... like... 3/4 of an inch high.

my SP-94 fits fine with my short NB cooler.
 
You must log in or register to reply here.
Back
Top