IC7 Max 3 problems

Joined
Jul 13, 2003
Messages
52
I just bought the TDK 8x DVD+/-R burner and installed it along with my old dvd drive. So now I have 2 sata drives and 3 cd/dvd drives installed in my computer. When I installed the 2 dvd drives it wont boot the hd.

It says "verifying DMI Pool Data .........." and the says "Boot from CD:" Nothing happens after that.

This has happened to me before whenever I up the fsb on my 2.8G p4. Anytime i raise the fsb and reboot it looses the boot info on the hd. And if I change the fsb back to stock it still wont boot the hd.

Anyone have any ideas why it does this? Is there an easier way to get the boot info back than having to reinstall windows?
 
Two questions.

What is your boot order? And have you enabled the On-Board SATA chip provided by the motherboard as a controller?

If those aren't set up properly, it can definitely ruin your day.

Dark Assassin
 
I have it booting as:
1) Floppy
2) CDROM
3) HD

I have the onboard SATA enabled and in enhanced mode.
 
Well, your boot order appears to be the culprit. In that order, your system will always prompt a boot up option from an optical drive.

The remedy: Set the hard drive as your primary boot device.

It doesn't boot from the CD because you don't prompt it to via pushing a button. Thus, it'll restart and attempt to boot from the CD-ROM again.

As I said, set your hard drive to the primary boot device and let me know what happens.

Dark Assassin
 
I would recommend also getting the latest BIOS, it fixed a few issues I was having with IDE detection.
 
It works in that order and it will boot up the cd. My WD Raptor HD failed on me so I am going to have to get a new one. I hope that it was the HD that was causing these boot issues. If it still messes up when I try to overclock with the new HD installed I will try the boot order you suggested.
 
Originally posted by Dark Assassin
Well, your boot order appears to be the culprit. In that order, your system will always prompt a boot up option from an optical drive.

The remedy: Set the hard drive as your primary boot device.

It doesn't boot from the CD because you don't prompt it to via pushing a button. Thus, it'll restart and attempt to boot from the CD-ROM again.

As I said, set your hard drive to the primary boot device and let me know what happens.

Dark Assassin

You are wrong on that, if there is no bootable media in any optical drive then it will attempt to skip past and try to boot off the HDD's. The raised FSB may be causing the SATA and IDE controllers to flake out and hence you only see the problem when overclocking....
 
just a question, are the agp/pci frequencies locked? cause if they arent you will certainly have trouble with the onboard/chip sata, which in turn will only look to boot off the less troubled optical drive.
 
I fixed the problem. I replace the motherboard, ram, cpu, hdd, and psu and it runs great now. Thanks to everyone that helped out.
 
so basicly you built a whole new computer ? lol. i have the ic7g max2. ive always loved that motherboard.
 
Back
Top