IBM System x3550 M3 slow writes

vr.

Supreme [H]ardness
2FA
Joined
Mar 30, 2010
Messages
4,892
Got my hands on an IBM x3550 x 8 SAS drive system. Slapped a RAID6 on it with 64K, told the web bios to use read-ahead and that there was a BBU even though there isn't, installed 2008R2 then ran ATTO on it.

How can I get these writes up?

ibmdiskraid6speedtest.png
 
I believe there should be a setting on the device itself. If not try clicking the checkbox that windows warns about in your picture..
 
I believe there should be a setting on the device itself. If not try clicking the checkbox that windows warns about in your picture..

I found the Disk Cache was set to Disable so I changed it to Enable
ibmmegaraidvirtualdrive.png


Re-ran ATTO
ibmmegaraidafterdiskcac.png


Changed Windows cache policy
ibmserveraidcacheenable.png


Rebooted, re-ran ATTO
ibmmegaraidcacheenabled.png


Any other suggestions are greatly appreciated!
 
Does it still say "Current Write: Write Through" on the MegaRAID bios?

That is the bad part. You should get 10 times the write rate if this is Write Back.
 
Does it still say "Current Write: Write Through" on the MegaRAID bios?

That is the bad part. You should get 10 times the write rate if this is Write Back.

It said Write Through until I found, downloaded and installed the LSI MegaRAID Management software. After modifying the policy to Always Write Back instead of the option of Write Back with BBU . . . .
ibmserveraidwriteback.png


The policy finally says Write Back and the speeds are much improved!
ibmserveraidbetter.png


Thanks!
 
Does this seem a little unrealistic? I set the MegaRAID IO Policy to cached in the virtual disk and unchecked Direct I/O in ATTO.

ibmserveraiddirectiounc.png
 
The first benchmarks seem fine. But 2GB /s is not possible with 8 hard drives this must be using system ram as part of the cache.
 
Back
Top