I7 975 + Asus P6T SE

KrazeyKami

n00b
Joined
Dec 31, 2010
Messages
61
Hi all,

My setup:
i7 975
Asus P6T SE
12 GB OCZ3G1333LV2G (which runs at 1066 at stock, had to manually up the DRAM to 1333 and set 9-9-9-20 timings)


I just got an i7 975 and read a bit about OC.
I saw examples where you can leave everything stock (turn off speedstep and c-state) and just up the multiplier. Some could up to 28x and have a core voltage of 1.242.

I however, noticed the following:

At stock, I run around and below the 1.0V:
1.jpg


When upping the multiplier to 27, I already have a CVoltage of 1.272..
2.jpg


And at 29, I hit 1.440...
3.jpg



As where this guy claims to get to x28 at 1.242 w/o tweaking, and he actually has to modify the vcore settings to get it run at 4,1 MHz (x31), with the same voltage as I already have at x29.
http://www.anandtech.com/show/2777/9

How come my voltage is so high? I haven't actually changed anything, apart from letting my memory run at 1333:
4.jpg


I tried reverting those settings all back to Auto, but the voltage still was too high (no change).


I would like to run on a stable 3.8 w/o having to change my core voltage, and I think 1.4 is a bit too high compared to the various examples right?
Anything else I should change?

Regards,
Kami.
 
Have you started to test for stability? Are you attempting to manually set the voltages? I haven't tried the "auto" method as some suggest.

I'm currently OCing an i7 920 D0 with the same motherboard and have been getting random issues. Either my PSU isn't powerful enough (it's a highend corsair, but also powering an OCed 7950) or my RAM is being a bit** (I keep having to up the voltage, despite keeping it under spec).

The 920 comes stock at 2.66. I can get it to 4.2ghz and into Windows with vcore at 1.275 and QPI at 1.31, but I BSOD after a few. I can get somewhat stable at 3.95ghz and stable at 3.75ghz. Haven't found the sweet spot.

I would think you'd be capable of much more, given your chip compared to mine. I'll follow along to see what results you get.
 
The reason your voltage is so high is that you have it left to auto. You need to manually set the voltage to a set value or your motherboard will keep adding volts as you up the multiplier. This in turn will / may fry your chip if it gets too high. For what you are aiming for, I would keep it below 1.35 or so if possible.
 
Thx for the replies all.
Just to be 'save', I used Asus' Turbo-V tool to find the lowest possible voltage.
However, I didn't get any stable results at the voltages I should see (was still ~1.3v where people seem to easily have ~1.1v).
In the end I decided to leave it stock ;) With the speedstep etc, i'm doing 3.6 at 1.2v. Think it should be enough for my work :)

5.jpg
 
Back
Top