There's a thin piece of metal bent at an angle over one of the ports on the back of the mobo. It's sort of disabling any possibility of installing the panel correctly to the back of the case. Most topics I've read about it say just to bend it flat, meaning it'll just slide under the panel (not the motherboard itself), and out the case. Is that what I'm supposed to do?
Annoyance can be seen at the bottom left of this pic:
http://www.brightsideofnews.com/Data/2009_10_23/Asus-P7P55D-E-Premium-Specs-Revealed/P6X58D-P-02.jpg
What do you guys think?
Annoyance can be seen at the bottom left of this pic:
http://www.brightsideofnews.com/Data/2009_10_23/Asus-P7P55D-E-Premium-Specs-Revealed/P6X58D-P-02.jpg
What do you guys think?