• Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
    Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.

I/O controller issues...

R

Ripskin

2[H]4U
2FA
Joined
Jan 15, 2004
Messages
2,593
I have a Belkin Ultra ATA/133 pci controller card and a maxtor 250 and WD 180 plugged into it, with a 120 gig on the motherboard. When I hook up the drives on the controller as master / slave or CS or anything i cannot get them to show up right, its either I get some random drive that causes windows to take 10 min to load, or I only see the 250 gig. I cannot get the 180 to show up unless i put it on the motherboard.

Any suggestions?
 
Check for driver and BIOS updates to the card.

Is the 180 partitioned and formatted? If not, do so with it connected to the mainboard, then put it on the card.
 
Ill look,

I had been using it as a 130 off the mainboard for about a year now and finally got around to getting a controller and the new HDD. Its got the partitions and so forth made at from windows a year ago.
 
You must log in or register to reply here.
Back
Top